Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Crush Can - Front - LH - Install

Tesla Model 3 2017-2023 Service Manual / Body / Bumper / Fascia / Crush Can - Front - LH (Remove and Replace) / Crush Can - Front - LH - Install

Install

Crush Can - Front - LH (Remove and Replace)

  1. Install the LH front crush can into the LH front inner rail.

Note: Lightly tap the crush can with a dead blow harmer to assist with installation into the inner rail.

Crush Can - Front - LH (Remove and Replace)

  1. install the bolt that attaches the LH front fender support to the LH front crush can. Torque 35 Nm

Crush Can - Front - LH (Remove and Replace)

Install the bolts (x4) that attach the LH front crush can to the LH front inner rail. Torque 90 Nm

Crush Can - Front - LH (Remove and Replace)

  1. Fasten the clips (x3) that attach the electrical harness to the LH front crush can.

Crush Can - Front - LH (Remove and Replace)

  1. Lift the condenser fan module off of the front subframe, and then install the bolts (x2) that attach the bottom of the condenser fan module to the ankle catcher. Torque 10 Nm

Note: Lift the condenser fan module up to ease installation of the bolts.

Crush Can - Front - LH (Remove and Replace)

  1. Install the front bumper with energy absorbers into the LH and RH crush cans, and then install the bolts (x4) that attach the front bumper to the crush cans. Torque 75 Nm

Crush Can - Front - LH (Remove and Replace)

  1. Connect the electrical harness to the RH front airbag sensor connector.

Crush Can - Front - LH (Remove and Replace)

  1. Connect the electrical harness to the center front airbag sensor connector.

Crush Can - Front - LH (Remove and Replace)

  1. Connect the electrical harness to the LH front airbag sensor connector.
  2. Install the front fascia assembly.
  3. Install the underhood storage unit.
  4. Install the hood latch cover.
  5. Install the cabin intake duct.
  6. Install the rear underhood apron.
  7. Remove the vehicle from the lift.

    READ NEXT:

     Fascia - Front (Remove and Install)

    Remove Remove the rear underhood apron. Remove the cabin intake duct. Remove the hood latch cover. Remove the underhood storage unit carpet Remove the underhood storage unit. Remove th

     Fascia - Front (Remove and Replace)

     Fascia - Front (Remove)

    Remove Remove the front license plate bracket. Remove the front fascia. Disconnect the electrical harness from the RH front turn signal/fog light connector. Release the clips that atta

    SEE MORE:

     Obstacle-Aware Acceleration

    Obstacle-Aware Acceleration is designed to reduce the impact of a collision by reducing motor torque if Model 3 detects an object in its driving path. For example, Model 3, while parked in front of a closed garage door with the Drive gear engaged, detects that you have pressed hard on the acce

     Operating Autosteer

    Before you can operate Autosteer, you must enable it by touching Controls > Autopilot > Autosteer (Beta). To indicate that Autosteer is available (but not actively steering Model 3), the touchscreen displays a gray Autosteer icon. To initiate Autosteer, move the gear lever fully down

    © 2019-2023 Copyright www.tmodel3.com