Tesla Model 3: Fascia - Front (Remove)
.jpg)
Remove

- Remove the front license plate bracket.
- Remove the front fascia.
- Disconnect the electrical harness from the RH front turn signal/fog
light connector.

- Release the clips that attach the electrical harness to the front turn
signal/fog light.

- Remove the screws that attach the front turn signal/fog light to the
front fascia
- Use a trim tool to release the tabs (x4) that attach the front turn
signal/fog light to the front fascia, and then remove the light from the
front fascia.
- Repeat step 3 through step
5 for the LH front turn signal/fog light.

LH Front Parking Assist Sensor Shown
- Disconnect the electrical harness from all of the front parking distance
sensors connectors (x6).

LH Front Parking Assist Sensor Shown
- Release the clips that attach the parking distance sensors to the front
fascia, and then remove the sensors (x6) from the fascia.

- Disconnect the electrical harness from the ambient air temperature
sensor connector

- Release the clips that attach the electrical harness to the front fascia,
and then remove the electrical harness from the fascia.

- Release the clips that attach the tow hook cover to the front fascia,
and then remove the cover from the fascia.

- Remove the screws that attach the front fascia grille to the front
fascia.

Top
- Release the clips (x9) that attach the front fascia grille to the front
fascia, and then remove grille from the fascia.

Bottom
READ NEXT:
Install
Installation procedure is the reverse of removal.
Top
Bottom
Install the front fascia grille onto the front fascia, and then fasten
the clips (x9) that attach the grille to the fascia.
Remove
Remove the 2nd row lower seat cushion
Remove the trunk sill trim.
Remove the LH and RH taillights.
On each side of the vehicle, remove the bolt that attaches the corner of
the rear
DRAFT
Warning:
This procedure was derived from pre-production computer models, and
might not reflect the real-world situation. Warnings and cautions might be
missing. Follow safety requirements
SEE MORE:
SPECIAL TOOLS
Kit, Spoiler Alignment, M3 (1479070-00-A )
Procedure
Clean the installation surface of the spoiler with isopropyl alcohol
(IPA) wipes, and allow it to dry before continuing.
Note: Clean any moisture or contaminates that might be present from
rain or vehicle washing, otherwise
Install
Caution:
Replace all patchbolts.
Replace all nyloc nuts.
Use an IPA wipe to clean any residue from the high voltage controller
mounting bolt holes and both the inside and outside of the penthouse cover
at the bolt holes.
If the aluminum tape retrofit patch is damaged, remove it,