Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Windshield (Remove and Install)- Windshield Preparation

Tesla Model 3 2017-2023 Service Manual / Body / Windshield and Body Glass / Windshield (Remove and Install) / Windshield (Remove and Install)- Windshield Preparation

Windshield Preparation

  1. Use a razor blade and a blade scraper to remove the old urethane from the windshield flange on the vehicle.

Windshield (Remove and Install)- Windshield Preparation

  1. Install the GPS antenna into the windshield bracket, and then install the screw that attaches the GPS antenna to the bracket.   Torque 1 Nm

Windshield (Remove and Install)- Windshield Preparation

  1. Install the windshield electrical harness to the windshield bracket, and then install the screw that attaches the harness to the bracket.  Torque 1 Nm

Note: Make sure the windshield electrical harness is routed inside of the bracket.

Windshield (Remove and Install)- Windshield Preparation

  1. Connect the electrical connector to the GPS antenna.

Windshield (Remove and Install)- Windshield Preparation

  1. Connect the windshield electrical connector to the humidity and temperature sensor.

Windshield (Remove and Install)- Windshield Preparation

  1. Install the screws that attach the forward facing camera mount plate to the windshield. Torque 1 Nm

Windshield (Remove and Install)- Windshield Preparation

  1. Install the fastener track on the windshield, and then connect the clips (x6) that attach the windshield electrical harness on the fastener track.

Windshield (Remove and Install)- Windshield Preparation

  1. Temporarily secure the windshield electrical harness end towards the center of the windshield using tape.

    READ NEXT:

     Windshield (Remove and Install)- Install

    Install Note: Use soft materials to protect the windshield and to prevent scratching. Attach suction cups to the LH and RH sides of the windshield on the outside side of the windshield. W

     Windshield (Remove and Replace)

     Windshield (Remove and Replace) - Remove

    Remove Remove the cowl screen panel. See Panel - Cowl Screen (Remove and Replace). Disconnect the electrical harness from the windshield heater connector. Partially close the hood. Caut

    SEE MORE:

     Bumper - Front (Remove and Replace)

    Remove Raise and support the vehicle. Remove the rear underhood apron Remove the cabin intake duct. Remove the hood latch cover. Remove the underhood storage unit. Remove the front fascia assembly. Remove the LH front airbag sensor. Remove the center front airbag sensor. Remove the RH fr

     Latch - Door - Front - LH (Remove and Replace)

    Remove Remove the front LH door closeout panel. See Closeout Panel - Door - Front - LH (Remove and Install). Disconnect the electrical harness from the door latch connector.

    © 2019-2023 Copyright www.tmodel3.com