Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Steering Column (Remove and Replace)

Steering Column - Remove

 Steering Column (Remove and Replace)

Note:

This procedure was formulated using a release candidate or production model. Follow safety requirements and use extreme caution when working on or near high-voltage systems and components.

Remove

  1. Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
  2. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  3. Remove the cabin intake duct. See Duct - Cabin Intake (Remove and Replace).
  4. Remove the hood latch cover. See Cover - Hood Latch (Remove and Replace).
  5. Remove the underhood storage unit. See Underhood Storage Unit (Remove and Replace).

  Steering Column - Remove

  1. Remove the bolt that attaches the intermediate shaft to the steering rack assembly, and then slide the intermediate shaft upwards.
  2. Remove the LH and RH instrument panel end caps. See End Cap - Instrument Panel - LH (Remove and Replace).
  3. Remove the LH and RH middle A-pillar trims. See Trim - A-Pillar - Middle - LH (Remove and Replace).
  4. Remove the LH and RH lower A-pillar trims. See Trim - A-Pillar - Lower - LH (Remove and Replace).
  5. Remove the LH and RH upper A-pillar trims. See Trim - A-Pillar - Upper - LH (Remove and Replace).
  6. Remove the driver footwell cover. See Cover - Footwell - Driver (Remove and Replace).
  7. Remove front passenger footwell cover. See Cover - Footwell - Passenger (LHD) (Remove and Replace).
  8. Remove the driver seat and front passenger seat. See Seat - Driver (Remove and Replace).
  9. Disconnect 12V power. See 12V Power (Disconnect and Connect).
  10. Remove the driver knee airbag. See Airbag - Knee - Driver (Remove and Install).
  11. Remove the LH footwell duct. See Duct - Footwell - LH (Remove and Replace).
  12. Remove the center console. See Center Console (Remove and Install).
  13. Remove the front passenger knee airbag. See Airbag - Knee - Front Passenger (Remove and Replace).
  14. Remove the LH and RH end caps. See End Cap - Air Wave - LH (Remove and Replace).
  15. Remove the main instrument panel decor trim. See Decor Trim - Instrument Panel - Main (Remove and Replace).
  16. Remove the glove box. See Glove Box (LHD) (Remove and Replace).
  17. Remove the RH footwell duct. See Duct - Footwell - LH (Remove and Replace).
  18. Remove the driver airbag. See Airbag - Driver (Remove and Replace).
  19. Remove the steering wheel. See Steering Wheel (Remove and Install).
  20. Remove the restraint control module. See Module - Restraint Control (Remove and Replace).
  21. Remove the touchscreen. See Touchscreen (Remove and Replace).
  22. Remove the vent finisher. See Finisher - Vent (Remove and Replace).
  23. Remove the LH and RH air wave ducts. See Duct - Air Wave - RH (Remove and Replace) and Duct - Air Wave - LH (Remove and Replace).
  24. Remove the instrument panel speaker grille. See Grille - Speaker - Instrument Panel (Remove and Replace).
  25. Remove the LH, center, and RH dash speakers. See Speaker - Dash - LH (Remove and Replace) and Speaker - Dash - Center (Remove and Replace).
  26. Remove the front passenger airbag. See Airbag - Front Passenger (Remove and Install).
  27. Remove the IP carrier. See IP Carrier (Remove and Install).

  Steering Column - Remove

  1. Disconnect the electrical harness from the steering column connector.

  Steering Column - Remove

  1. Release the steering shaft boot from the bulkhead, and then pull it up from the bulkhead.

  Steering Column - Remove

  1. Remove the nuts that attach the steering column to the cross car beam.
  2. Lower the steering column, and then remove the steering column from the vehicle.

Steering Column - Install

Install

  1. Put the steering column in the vehicle for installation.

  Steering Column - Install

  1. Install the nuts that attach the steering column to the cross car beam. Torque 15 Nm

  Steering Column - Install

  1. Install the steering shaft boot into the bulkhead.

  Steering Column - Install

  1. Connect the electrical harness to the steering column connector.
  2. Install the IP carrier. See IP Carrier (Remove and Install).
  3. Install the front passenger airbag. See Airbag - Front Passenger (Remove and Install).
  4. Install the LH, center, and RH dash speakers. See Speaker - Dash - LH (Remove and Replace) and Speaker - Dash - Center (Remove and Replace).
  5. Install the instrument panel speaker grille. See Grille - Speaker - Instrument Panel (Remove and Replace).
  6. Install the LH air wave duct. See Duct - Air Wave - LH (Remove and Replace).
  7. Install the RH air wave duct. See Duct - Air Wave - RH (Remove and Replace).
  8. Install the vent finisher. See Finisher - Vent (Remove and Replace).
  9. Install the touchscreen. See Touchscreen (Remove and Replace).
  10. Install the restraint control module. See Module - Restraint Control (Remove and Replace).
  11. Install the steering wheel. See Steering Wheel (Remove and Install).
  12. Install the driver airbag. See Airbag - Driver (Remove and Replace).
  13. Install the RH footwell duct. See Duct - Footwell - LH (Remove and Replace).
  14. Install the glove box. See Glove Box (LHD) (Remove and Replace).
  15. Install the main instrument panel decor trim. See Decor Trim - Instrument Panel - Main (Remove and Replace).
  16. Install the LH and RH end caps. See End Cap - Air Wave - LH (Remove and Replace).
  17. Install the front passenger knee airbag. See Airbag - Knee - Front Passenger (Remove and Replace).
  18. Install the center console. See Center Console (Remove and Install).
  19. Install the front passenger seat. See Seat - Driver (Remove and Replace).
  20. Install the LH footwell duct. See Duct - Footwell - LH (Remove and Replace).
  21. Install the driver knee airbag. See Airbag - Knee - Driver (Remove and Install).
  22. Install the driver seat. See Seat - Driver (Remove and Replace).
  23. Reconnect 12V power. See 12V Power (Disconnect and Connect).
  24. Install front passenger footwell cover. See Cover - Footwell - Passenger (LHD) (Remove and Replace).
  25. Install the LH and RH upper A-pillar trims. See Trim - A-Pillar - Upper - LH (Remove and Replace).
  26. Install the LH and RH middle A-pillar trims. See Trim - A-Pillar - Middle - LH (Remove and Replace).
  27. Install the LH and RH instrument panel end caps. See End Cap - Instrument Panel - LH (Remove and Replace).
  28. Slide the intermediate shaft downwards into the steering rack assembly. Note: With an assistant, align the intermediate shaft to the steering rack, if necessary.

  Steering Column - Install

  1. Install the bolt that attaches the intermediate shaft to the steering rack assembly. Torque 18 Nm
  2. Install the underhood storage unit. See Underhood Storage Unit (Remove and Replace).
  3. Install the hood latch cover. See Cover - Hood Latch (Remove and Replace).
  4. Install the cabin intake duct. See Duct - Cabin Intake (Remove and Replace).
  5. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  6. Install the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).

    READ NEXT:

     Steering Wheel (Remove and Install)

    Remove Set the vehicle's front wheels straight and the steering wheel centered. Remove the 2nd row lower

    SEE MORE:

     Vent Assembly - HV Battery - RH (Remove and Replace)

    Remove Use Toolbox to put the vehicle into Factory Mode. Invoke diagnostics on the touchscreen. Inspect the Notifications for either a BMS_a123 or a BMS_W123 alert. If: Either alert is present - Contact Service Engineering. Do not perform this procedure. Neither alert is present - Continu

     Gas Strut - Trunk - LH (Remove and Replace)

    Remove Open the trunk, and support the trunk in the open position. Release the clip that attaches the lower end of the LH trunk gas strut to the hinge on the vehicle. Release the clip that attaches the upper end of the LH trunk gas strut to the hinge on the trunk lid, and then r

    © 2019-2025 Copyright www.tmodel3.com