Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Hub - Rear - LH (Remove and Replace)

Tesla Model 3 2017-2026 Service Manual / Suspension / Rear Suspension (Including Hubs) / Hub - Rear - LH (Remove and Replace)

Hub - Rear - LH (Remove and Replace)

Remove

  1. Remove the LH rear brake rotor. See Brake Rotor - Rear - LH (Remove and Replace).
  2. Remove the LH rear drive unit halfshaft. See Halfshaft - Rear Drive Unit - LH (Remove and Replace).

Hub - Rear - LH (Remove and Replace)

  1. Remove and discard the bolts that attach the LH rear hub to the knuckle, and remove the hub from the vehicle. Torque 85 Nm

Install

Installation procedure is the reverse of removal, except for the following:

Caution: Replace all patchbolts.

    READ NEXT:

     Knuckle - Suspension - Rear - LH (Remove and Replace)

    Knuckle - Suspension - Rear - LH - Remove   SPECIAL TOOLS Tool, Spring Compressor, Hook, Model 3 (1135103-00-A)

    SEE MORE:

     USB Hub - Center Console - Front (Remove and Replace)

    Remove Remove the center console. See Center Console (Remove and Install). Disconnect the electrical wiring harness connector from the USB hub. Release the clips that attach the electrical harness to the USB hub. Remove the bolts that attach the USB hub to the center console, and

     Tie Rod End - LH (Remove and Replace)

        Raise and support the vehicle. See Raise Vehicle - 2 Post Lift. Remove the LH front wheel. See Wheel (Remove and Install).

    © 2019-2026 Copyright www.tmodel3.com