Tesla Model 3: Suspension
Tesla Model 3 2017-2026 Service Manual / Suspension
- Adjustment
- Front Suspension (Including Hubs)
- Front Upper Control Arm (FUCA) Mount - LH (Remove and Replace)
- Control Arm - Upper - Front - LH (Remove and Replace)
- Hub - Front - LH (Dual Motor) (Remove and Replace)
- Hub - Front - LH (RWD) (Remove and Replace)
- Knuckle - Suspension - Front - LH (Dual Motor) (Remove and Replace)
- Knuckle - Suspension - Front - LH (RWD) (Remove and Replace)
- Link - Compliance - Lower - Front - LH (Remove and Replace)
- Link - Lateral - Lower - Front - LH (Remove and Replace)
- Link - Stabilizer Bar - Front - LH (Remove and Replace)
- Stabilizer Bar - Front (Remove and Replace)
- Suspension - Front (Check Torque)
- Rear Suspension (Including Hubs)
- Cover - Rear Suspension - LH (Remove and Replace)
- Drop Link - Stabilizer Bar - Rear - LH (Remove and Replace)
- Hub - Rear - LH (Remove and Replace)
- Knuckle - Suspension - Rear - LH (Remove and Replace)
- Link - Aft - Lower - Rear - LH (Remove and Replace)
- Link - Fore - Lower - Rear - LH (Remove and Replace)
- Link - Fore - Upper - Rear - LH (Remove and Replace)
- Stabilizer Bar - Rear (Remove and Replace)
- Suspension - Rear (Check Torque)
- Toe Link - Rear - LH (Remove and Replace)
- Coil Suspension System
READ NEXT:
Four Wheel Alignment (Check)
SPECIAL TOOLS
SEAT COVER (1096767-00-A)
Ballast Bag, 25lb (1145158-00-A)
CHASSIS HEIGHT MEASURING TOOL (1071271-00-A)
STEERING WHEEL LEVEL (1049463-00-A)
Procedure
Make sure the tire pressures are t
Four Wheel Alignment (Check and Adjust)
Prepare for Adjustment
SPECIAL TOOLS
SEAT COVER (1096767-00-A)
Ballast Bag, 25lb (1145158-00-A)
CHASSIS HEIGHT MEASURING TOOL (1071271-00-A)
STEERING WHEEL LEVEL (1049463-00-A)
Prepare for Adjustment
SEE MORE:
Seal - Outer Belt - Rear Door - LH (Remove and Replace)
Note:
This procedure was formulated using a release candidate or production
model. Follow safety requirements and use extreme caution when working on or
near high-voltage systems and components.
Remove
Open the LH rear door and lower the window.
Pry the outer belt seal from the rear do
Pressure Transducer - Low Pressure (Remove and Replace)
Remove
Recover the A/C refrigerant. See A/C Refrigerant (Recovery and Recharge).
Note: Completely recover the refrigerant before continuing this
procedure.
Disconnect 12V power. See 12V Power (Disconnect and Connect).
Disconnect the electrical connector to the low pressure transducer.
© 2019-2026 Copyright www.tmodel3.com
