Tesla Model 3: Coil Suspension System
Tesla Model 3 2017-2026 Service Manual / Suspension / Coil Suspension System
- Damper - Rear - LH (Coil Suspension) (Remove and Replace)
- Spring - Rear Suspension - LH (Remove and Replace)
- Spring and Damper Assembly - Front - LH (Remove and Replace)
READ NEXT:
Damper - Rear - LH (Coil Suspension) (Remove and Replace)
Remove
Raise and support the vehicle on a 2 post lift. See
Raise Vehicle - 2 Post Lift.
Spring - Rear Suspension - LH (Remove and Replace)
Spring - Rear Suspension - LH - Remove
SPECIAL TOOLS
Tool, Spring Compressor, Hook, Model 3
(1135103-00-A)
SEE MORE:
Fascia - Front (Remove and Replace)
Fascia - Front (Remove)
Remove
Remove the front license plate bracket.
Remove the front fascia.
Disconnect the electrical harness from the RH front turn signal/fog
light connector.
Release the clips that attach the electrical harness to the front turn
signal/fog light.
Remove
Forward Facing (Target Calibration)
SPECIAL TOOLS
Camera Calibration Target (1053066-00-A)
Wrench, 2.5mm, Thin (1448868-00-A)
Note: This procedure describes how to calibrate the forward
facing cameras. It does not apply to the rear facing camera.
Setup
Park the vehicle on a flat surface with at least 106 cm (3.5 ft) of
space in
© 2019-2026 Copyright www.tmodel3.com
