Tesla Model 3: Airbag - Side - Driver (Remove and Replace)

DRAFT
Warning:
This procedure was derived from pre-production computer models, and
might not reflect the real-world situation. Warnings and cautions might be
missing. Follow safety requirements and use extreme caution when working on or
near high voltage systems and components.
Remove
- Remove the driver seat backrest foam. See Foam - Backrest - Driver Seat
(Remove and Replace).
- Pull the seat back cover away from the foam assembly, and then remove
the side airbag from the seat.

Install
Installation procedure is the reverse of removal.
READ NEXT:
Note:
This procedure was formulated using a release candidate or production
model. Follow safety requirements and use extreme caution when working on or
near high-voltage systems and components.
Remove
Open all four doors, lower all four windows, and then move both front
seats forward.
Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd
Row (Remove and Replace).
Re
SEE MORE:
Remove
Remove the LH center console side panel carpet. See
Carpet - Side Panel - Center Console - LH (Remove and
Replace).
Disconnect 12V power. See 12V Power (Disconnect
Remove
Open the LH rear door.
Use narrow-width tape to carefully mark the location of the secondary
seal around the door.
Caution:
Make sure that the edge of the tape accurately follows the edge of the
seal.
Release the ends of the door secondary seal from the ends of the inner
bel