Tesla Model 3: Airbags
- Airbag - Curtain - LH (Remove and Replace)
- Airbag - Driver (Remove and Replace)
- Airbag - Front Passenger (Remove and Install)
- Airbag - Front Passenger (Remove and Replace)
- Airbag - Knee - Driver (Remove and Install)
- Airbag - Knee - Driver (Remove and Replace)
- Airbag - Knee - Front Passenger (Remove and Replace)
- Airbag - Side - Driver (Remove and Replace)
- Module - Restraint Control (Remove and Replace)
READ NEXT:
Airbag - Curtain - LH (Remove and Replace)
Airbag - Curtain - LH - Remove
DRAFT
Warning:
This procedure was derived from pre-production computer models, and
might not reflect the real-world situation. Warnings and cautions might be
missin
SEE MORE:
Subwoofer (Remove and Replace)
Remove
Disconnect 12V power. See 12V Power (Disconnect and Connect).
Remove the RH trunk side trim. See Trim - Side - Trunk - RH (Remove and
Replace).
Disconnect the electrical harness from the amplifier connectors.
Release the clips that attach the electrical harness to the subwoof
Brake Rotor - Rear - LH (Remove and Replace)
SPECIAL TOOLS
Tool, Caliper Spreader, Model 3 (1134786-00-A)
Remove
Raise the vehicle and remove the LH rear wheel. See
Wheel (Remove and Install).
Use Toolbox to place the vehicle into EPB Service Mode. See
Release Parking Brake Using Toolbox
Disconnect the electrical wiring harness con
© 2019-2026 Copyright www.tmodel3.com
