Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Airbag - Front Passenger (Remove and Replace)

Tesla Model 3 2017-2026 Service Manual / Safety and Restraint / Airbags / Airbag - Front Passenger (Remove and Replace)

Airbag - Front Passenger (Remove and Replace)

DRAFT

Warning:

This procedure was derived from pre-production computer models, and might not reflect the real-world situation. Warnings and cautions might be missing. Follow safety requirements and use extreme caution when working on or near high voltage systems and components

Remove

  1. Remove the IP carrier. See IP Carrier (Remove and Replace).

Airbag - Front Passenger (Remove and Replace)

  1. Apply pressure along the front edge of the airbag assembly, and while doing so, flex the IP passenger airbag surround to release each of the 6 airbag tabs from the IP carrier surround.

Airbag - Front Passenger (Remove and Replace)

  1. Pivot the airbag up, unhook the 7 tabs at the rear of the airbag from the IP carrier surround, and then remove the airbag from the IP carrier.

Install

Airbag - Front Passenger (Remove and Replace)

  1. Insert the 7 tabs of the rear of the airbag into the matching openings of the IP carrier surround.

Airbag - Front Passenger (Remove and Replace)

  1. Pivot the airbag into the IP carrier until the 6 tabs at the front of the airbag lock into place.
  2. Install the IP carrier. See IP Carrier (Remove and Replace).

    READ NEXT:

     Airbag - Knee - Driver (Remove and Install)

    Remove Remove the LH center console side panel carpet. See Carpet - Side Panel - Center Console - LH (Remove and Replace). Disconnect 12V power. See 12V Power (Disconnect and Connect). Remove

     Airbag - Knee - Driver (Remove and Replace)

    Note: This procedure was formulated using a release candidate or production model. Follow safety requirements and use extreme caution when working on or near high-voltage systems and components.

     Airbag - Knee - Front Passenger (Remove and Replace)

    Remove Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace). Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace). Disco

    SEE MORE:

     Tesla Badge - Rear (Remove and Replace)

    SPECIAL TOOLS Kit, Badge Removal (1453028-00-A) Fixture, Rear Badge, Model 3 (1134703-00-A) Remove Prepare the badge removal tool with approximately 60 centimeters of monofilament line. Raise the trunk lid, and position the badge removal tool so that the monofilament line cuts under a corn

     Fascia - Front (Remove and Install)

    Remove Remove the rear underhood apron. Remove the cabin intake duct. Remove the hood latch cover. Remove the underhood storage unit carpet Remove the underhood storage unit. Remove the bolts that attach the top of the front fascia to the vehicle.Torque 4 Nm Remove the front wheel

    © 2019-2026 Copyright www.tmodel3.com