Tesla Model 3: Safety and Restraint
Tesla Model 3 2017-2026 Service Manual / Safety and Restraint
- Airbags
- Airbag - Curtain - LH (Remove and Replace)
- Airbag - Driver (Remove and Replace)
- Airbag - Front Passenger (Remove and Install)
- Airbag - Front Passenger (Remove and Replace)
- Airbag - Knee - Driver (Remove and Install)
- Airbag - Knee - Driver (Remove and Replace)
- Airbag - Knee - Front Passenger (Remove and Replace)
- Airbag - Side - Driver (Remove and Replace)
- Module - Restraint Control (Remove and Replace)
- Seatbelts
- Buckle - 1st Row - LH (Remove and Replace)
- Buckle - 2nd Row - Center (Remove and Replace)
- Buckle - 2nd Row - LH (Remove and Replace)
- Adjustable Top Loop (Remove and Replace)
- Seatbelt - 1st Row - LH (Remove and Replace)
- Seatbelt - 2nd Row - Center (Remove and Replace)
- Seatbelt - 2nd Row - LH (Remove and Replace)
- Pretensioners
- Sensors
READ NEXT:
Airbag - Curtain - LH (Remove and Replace)
Airbag - Curtain - LH - Remove
DRAFT
Warning:
This procedure was derived from pre-production computer models, and
might not reflect the real-world situation. Warnings and cautions might be
missin
SEE MORE:
Pressure Transducer - Low Pressure (Remove and Replace)
Remove
Recover the A/C refrigerant. See A/C Refrigerant (Recovery and Recharge).
Note: Completely recover the refrigerant before continuing this
procedure.
Disconnect 12V power. See 12V Power (Disconnect and Connect).
Disconnect the electrical connector to the low pressure transducer.
Polish
Remove the cutting pad from the buffer, and then install a polishing pad on
the buffer.
Apply 4 evenly spaced 20 mm diameter dollops of polishing compound on the
polishing pad.
Set the buffer speed according to region, and while the buffer is off, place
the tool on top of the affected area.
NA:
© 2019-2026 Copyright www.tmodel3.com
