Tesla Model 3: Audio System - USB Media Port
Tesla Model 3 2017-2025 Service Manual / Infotainment / Audio System - USB Media Port
- USB Hub - Center Console - Front (Remove and Replace)
- USB Hub - Center Console - Rear (Remove and Replace)
READ NEXT:
USB Hub - Center Console - Front (Remove and Replace)
Remove
Remove the center console. See Center Console (Remove and Install).
Disconnect the electrical wiring harness connector from the USB hub.
Release the clips that attach the electric
USB Hub - Center Console - Rear (Remove and Replace)
Remove
Remove the center console air vent panel. See Panel - Air Vent - Center
Console (Remove and Replace).
Remove the screws that attach the vent unit to the center console air
vent pan
SEE MORE:
Bracket - License Plate - Front (EMEA) (Retrofit using Template)
Procedure
Clean the front center surface of the front fascia.
Align the template with the parking sensors, and then use masking tape
to hold the template in place.
LH side shown, RH side similar
Align the front license plate bracket over the template, and then secure
the bracket
Actuator - 5-Way Valve (RWD) (Remove and Replace)
SPECIAL TOOLS
Wrench, Diverter Valve, Model 3 (1447556-00-A)
Remove
Disconnect 12V power. See 12V Power (Disconnect and Connect).
Remove the front aero shield. See Panel - Aero Shield - Front (Remove
and Replace).
From under the vehicle, disconnect the electrical harness from the 5-way
© 2019-2025 Copyright www.tmodel3.com
