Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Breather - Front Drive Unit (Remove and Replace)

Tesla Model 3 2017-2026 Service Manual / Front Drive Unit / Front Gearbox and Halfshafts / Breather - Front Drive Unit (Remove and Replace)

Breather - Front Drive Unit (Remove and Replace)

Remove

  1. Remove the front subframe assembly. See Subframe Assembly - Front (Dual Motor) (Remove and Install).

Breather - Front Drive Unit (Remove and Replace)

  1. Remove the front drive unit breather. Torque 5 Nm

Install

Installation procedure is the reverse of removal.

    READ NEXT:

     Bushing - Gearbox - Front Drive Unit (Remove and Replace)

    Bushing - Gearbox - Front Drive Unit - Remove   SPECIAL TOOLS Engine Motor Stand, 1000 lb. (NA, APAC) (1

    SEE MORE:

     Headlights - Adjust - EMEA (Wall Method)

    Adjust Headlights Using a Wall Apply Tape to Wall Apply tape to a wall 23.6 in (60 cm) from the ground. Apply tape to the floor 31.1 ft (9.5 m) from the wall. Note: EU vehicles require a 1 to 1.5 degree downward inclination in the headlight beam. For example, a vehicle parked 10 m from the

     Trim - Floor - Trunk (Remove and Replace)

    Remove Open the rear trunk. Lift up the trunk floor trim and remove it from the vehicle. Tip: Use the pull tab located at the rear edge of the trunk floor trim. Install Installation procedure is the reverse of removal.

    © 2019-2026 Copyright www.tmodel3.com