Tesla Model 3: Front Gearbox and Halfshafts
Tesla Model 3 2017-2026 Service Manual / Front Drive Unit / Front Gearbox and Halfshafts
- Breather - Front Drive Unit (Remove and Replace)
- Bushing - Gearbox - Front Drive Unit (Remove and Replace)
- Gearbox Fluid - Front Drive Unit (Drain and Refill)
- Halfshaft - Front Drive Unit - LH (Remove and Replace)
- Heat Exchanger - Front Drive Unit (Remove and Replace)
- Hose - Heat Exchanger to Superbottle - Front Drive Unit (Remove and Replace)
- Oil Pump - Front Drive Unit (Remove and Replace)
- Oil Screen - Front Drive Unit (Remove and Replace)
- Seal - Oil - Differential to Halfshaft - Front Drive Unit - LH (Remove and Replace)
READ NEXT:
Breather - Front Drive Unit (Remove and Replace)
Remove
Remove the front subframe assembly. See
Subframe Assembly - Front (Dual Motor) (Remove and Install).
Remove the front drive unit breather.
Torque 5 Nm
Install
Installation pro
Bushing - Gearbox - Front Drive Unit (Remove and Replace)
Bushing - Gearbox - Front Drive Unit - Remove
SPECIAL TOOLS
Engine Motor Stand, 1000 lb. (NA, APAC)
(1
SEE MORE:
Remove Dirt Inclusion
Apply isopropyl alcohol to the general area of the defect, and then wipe
the area with a clean microfiber towel.
While wearing a nitrile glove, run hand over the area around the dirt
inclusion and check for fine bumps in the paint.
If bumps are detected, perform clay treatment on the
Coolant - HV Battery (Drain and Refill)
SPECIAL TOOLS
Drive Unit Pressure Test Fixture (1053600-00-B)
Adapter, Coolant Reservoir Pressure Test (1130942-00-B)
Kit, Coolant Leak Test Adapters, Model 3 (1132185-00-B)
Kit, Coolant Drain & Fill Adapters, M3 (1133843-00-A)
Kit, Svc Plug, Cooling Hose, Model 3 (1135762-00-A)
Kit, Battery C
© 2019-2026 Copyright www.tmodel3.com
