Tesla Model 3: Hose - Heat Exchanger to Superbottle - Front Drive Unit (Remove and Replace)

Tesla Model 3 2017-2026 Service Manual / Front Drive Unit / Front Gearbox and Halfshafts / Hose - Heat Exchanger to Superbottle - Front Drive Unit (Remove and Replace)

Hose - Heat Exchanger to Superbottle - Front Drive Unit (Remove and Replace)

Remove

Remove the superbottle. See Superbottle (Dual Motor) (Remove and Replace).

Hose - Heat Exchanger to Superbottle - Front Drive Unit (Remove and Replace)

Install

Installation procedure is the reverse of removal.

Caution:

Perform a push-pull test to verify that the hose is fully seated

SEE MORE:

Cover - Shock Tower - LH (Remove and Replace)

Remove Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace). Remove the cabin intake duct. See Duct - Cabin Intake (Remove and Replace). Remove the hood latch cover. See Cover - Hood Latch (Remove and Replace). Remove the underhood storage unit. See Underhood

Cover - Outer Side - Driver Seat (Remove and Install)

SPECIAL TOOLS Key, Seat Belt Release, Model 3 (1133787-00-A) Remove Open the LH front door. Move the driver's seat fully forward, and adjust the seat cushion height to maximum. Caution: Do not allow the seat headrest to compress the sun visor as it might crack the mirror. Insert the sea

Tesla Model 3: Hose - Heat Exchanger to Superbottle - Front Drive Unit (Remove and Replace)

READ NEXT:

Oil Pump - Front Drive Unit (Remove and Replace)

SEE MORE:

Cover - Shock Tower - LH (Remove and Replace)

Cover - Outer Side - Driver Seat (Remove and Install)