Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Fluid Coupling (55 Degrees) - Rear Drive Unit (Remove and Replace)

Tesla Model 3 2017-2026 Service Manual / Rear Drive Unit / Rear Drive Unit Assembly / Fluid Coupling (55 Degrees) - Rear Drive Unit (Remove and Replace)

 Fluid Coupling (55 Degrees) - Rear Drive Unit (Remove and Replace)

SPECIAL TOOLS

Kit, Svc Plug, Cooling Hose, Model 3 (1135762-00-A)

Remove

  1. Remove the mid aero shield panel. See Panel - Aero Shield - Mid (Remove and Replace).
  2. Place a coolant drain container underneath the rear drive unit.

  Fluid Coupling (55 Degrees) - Rear Drive Unit (Remove and Replace)

  1. Release the clip that attaches the hose to the 55 degree fluid coupling, and then remove the hose.
  2. Insert a plug in the hose.

  Fluid Coupling (55 Degrees) - Rear Drive Unit (Remove and Replace)

  1. Remove the fastener that attaches the 55 degree fluid coupling to the rear drive unit. Torque 6 Nm
  2. Remove the 55 degree fluid coupling from the rear drive unit.
  3. Insert a plug in the rear drive unit 55 degree fluid coupling opening.

Install

Installation procedure is the reverse of removal, except for the following:

Caution: Replace all patchbolts.

Caution: Perform a push-pull test to verify that the hose is fully seated.

  • Perform an inverter coolant leak test. See Inverter Coolant Leak Test.
  • Refill the coolant. See Powertrain Coolant (Drain and Refill).

    READ NEXT:

     Fluid Coupling (Straight) - Rear Drive Unit (Remove and Replace)

        SPECIAL TOOLS Kit, Svc Plug, Cooling Hose, Model 3 (1135762-00-A)

     Drive Unit - Rear (Remove and Install)

    Drive Unit - Rear- Remove   SPECIAL TOOLS Fixture, Subframe, Model 3 (1099645-00-B) Li

    SEE MORE:

     Seal - Outer Belt - Rear Door - LH (Remove and Replace)

    Note: This procedure was formulated using a release candidate or production model. Follow safety requirements and use extreme caution when working on or near high-voltage systems and components. Remove Open the LH rear door and lower the window. Pry the outer belt seal from the rear do

     Hub - Rear - LH (Remove and Replace)

    Remove Remove the LH rear brake rotor. See Brake Rotor - Rear - LH (Remove and Replace). Remove the LH rear drive unit halfshaft. See Halfshaft - Rear Drive Unit - LH (Remove and Replace). Remove and discard the bolts that attach the LH rear hub to the knuckle, and remove the hub from

    © 2019-2026 Copyright www.tmodel3.com