Tesla Model 3: Rear Drive Unit
Tesla Model 3 2017-2025 Service Manual / Rear Drive Unit
- Rear Drive Unit Assembly
- Bushing - Rear Drive Unit - Rear (Remove and Replace)
- Bushing - Rear Drive Unit - RH (Remove and Replace)
- Fluid Coupling (55 Degrees) - Rear Drive Unit (Remove and Replace)
- Fluid Coupling (Straight) - Rear Drive Unit (Remove and Replace)
- Drive Unit - Rear (Remove and Install)
- Drive Unit - Rear (Remove and Replace)
- Mount - Rear Drive Unit - LH (Remove and Replace)
- Rear Motor
- Rear Drive Inverter
- HV Header - Inverter - Rear Drive Unit (Remove and Replace)
- Inverter Air Leak Test
- Inverter Coolant Leak Test
- Inverter - Rear Drive Unit (Remove and Install)
- Inverter - Rear Drive Unit (Remove and Replace)
- Powertrain Coolant (Drain and Refill)
- Rear Gearbox and Halfshafts
- Breather - Rear Drive Unit (Remove and Replace)
- Filter - Oil - Rear Drive Unit (Remove and Replace)
- Gearbox - Rear Drive Unit (Remove and Replace)
- Gearbox Fluid - Rear Drive Unit (Drain and Refill)
- Halfshaft - Rear Drive Unit - LH (Remove and Replace)
- Heat Exchanger - Rear Drive Unit (Remove and Replace)
- Oil Pump - Rear Drive Unit(Remove and Replace)
- Oil Screen - Rear Drive Unit (Remove and Replace)
- Seal - Oil - Differential to Halfshaft - Rear Drive Unit - LH (Remove and Replace)
READ NEXT:
Bushing - Rear Drive Unit - Rear (Remove and Replace)
DRAFT
Warning:
This procedure was derived from pre-production computer
models, and might not reflect the real-world situation. Warnings
and cautio
Bushing - Rear Drive Unit - RH (Remove and Replace)
SPECIAL TOOLS
Kit, Drive Unit Bushing R&R, Model 3
(1137785-00-A)
Remove
SEE MORE:
Antenna - Wi-Fi
Antenna - Wi-Fi (Remove and Replace)
Remove
Remove the LH and RH side rail trims. See Trim - Side Rail - LH (Remove
and Install).
Open the LH and RH hook covers, and then release the clips that attach
the screw covers to the LH and RH coat hooks.
Remove the screws that attach the LH
Sensor - Radar - Front (Calibration)
Calibrate
Perform a 4-wheel alignment. See Four Wheel Alignment (Check and Adjust).
Connect a laptop with Toolbox to the vehicle.
With an assistant, use Toolbox to perform a radar drive cycle
calibration:
For new radar applications, proceed to step 4.
For existing radar applications,
© 2019-2025 Copyright www.tmodel3.com
