Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Rear Motor

READ NEXT:

 Motor Assembly - Rear (Remove and Replace)

    Remove Remove the rear drive unit. See Drive Unit - Rear (Remove and Replace). Remove the rea

 Sensor - Rear Motor - Speed (Remove and Replace)

  Special tool required for this procedure: 1451839-00-A SKT, EP10 LOW PROFILE 1115031-00-A EXT, WOBBLE, 1/4" DR, 1.25"

 Rear Drive Inverter

SEE MORE:

 Trim - Sill - Trunk (Remove and Replace)

Remove Remove the trunk floor trim. See Trim - Floor - Trunk (Remove and Replace). Release the clips that attach the trunk sill trim to the body. Tip: Pull the corner of the trunk sill trim upwards to release the corner clip, and then release the remaining clips. Remove the tru

 Sensor - Parking Distance - Rear - Each (Remove and Replace)

Remove Remove the rear fascia. See Fascia - Rear (Remove and Install). Disconnect the electrical harness from the rear parking distance sensor connector. Release the clips that attach the rear parking distance sensor to the rear fascia, and then remove the sensor from the rear fasc

© 2019-2026 Copyright www.tmodel3.com