Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Breather - Rear Drive Unit (Remove and Replace)

Tesla Model 3 2017-2025 Service Manual / Rear Drive Unit / Rear Gearbox and Halfshafts / Breather - Rear Drive Unit (Remove and Replace)

Breather - Rear Drive Unit (Remove and Replace)

Remove

  1. Remove the rear subframe assembly. See Subframe Assembly - Rear (Remove and Install).

Breather - Rear Drive Unit (Remove and Replace)

  1. Remove the breather from the rear drive unit.

Install

Breather - Rear Drive Unit (Remove and Replace)

  1. Install the breather onto the rear drive unit. Torque 5 Nm
  2. Install the rear subframe assembly. See Subframe Assembly - Rear (Remove and Install).

    READ NEXT:

     Filter - Oil - Rear Drive Unit (Remove and Replace)

    SPECIAL TOOLS Skt, Oil Filter, 63.5mm X 14 (1130484-00-A) Kit, Drive Unit Oil Drain, Model 3 (1134264-00-A) Procedure

     Gearbox - Rear Drive Unit (Remove and Replace)

    Remove Remove the rear drive unit inverter. See Inverter - Rear Drive Unit (Remove and Install). Setup

     Gearbox Fluid - Rear Drive Unit (Drain and Refill)

    Gearbox Fluid - Rear Drive Unit - Drain   Drain SPECIAL TOOLS KIT, DRIVE UNIT OIL DRAIN, MODEL

    SEE MORE:

     Fascia - Rear (Remove and Install)

    Remove Remove the 2nd row lower seat cushion Remove the trunk sill trim. Remove the LH and RH taillights. On each side of the vehicle, remove the bolt that attaches the corner of the rear fascia to the body. Torque 4 Nm Raise the vehicle partially. Release the clips and the push nut

     Garnish - Trunk (Remove and Replace)

    Remove LH shown, RH similar Open the trunk. Release the clips (x2) that attach the ends of the trunk garnish to the body. Release the tabs (x10) that attach the trunk garnish to the body, and then remove the trunk garnish from the vehicle. Install Installation procedure is the

    © 2019-2025 Copyright www.tmodel3.com