Tesla Model 3: Harness - HV Battery to Rear Drive Unit - Remove
SPECIAL TOOLS
Lever Lock, HV Connector, Model 3 (1140311-00-A)
Remove
- Remove the rear subframe assembly. See Subframe
Assembly - Rear (Remove and Install).
- Disconnect the electrical harness from the inverter
low voltage connector.
- Release the clip that attaches the low voltage
electrical harness to the inverter.
- Release the clip, disconnect the rear drive unit
inlet hose from the inverter coolant inlet, and then
plug the inlet.
- Release the clip that attaches the rear drive unit
inlet hose to the HV harness bracket, and then remove
the hose from the rear drive unit.
- Remove the bolt that attaches the HV harness bracket
to the inverter.
- Slide the release to unlock the HV harness
connector.
- Lift the handle on HV harness connector, disconnect
the harness from the inverter connector, and then remove
the harness from the rear drive unit.
READ NEXT:
Install
Fully raise the handle on the rear drive unit HV
electrical harness.
Mobile Connector
Firmware Update - CHAdeMO Charging Adapter
CAN Setup
Connect the USB-CAN dongle to a laptop that is equipped with Toolbox
Connect the CHAdeMO CAN programming connector to the USB-CAN
SEE MORE:
The following best practices can help ensure
that you have the best ownership experience
possible in harsh cold weather conditions.
Before Driving
Warm the cabin and Battery ahead of
departure for maximum range and
performance. There are several ways to
precondition your vehicle:
Mobile a
Remove
Open all doors and lower all windows.
Open the hood.
Remove the rear underhood apron. See Underhood Apron - Rear (Remove and
Replace).
Remove the cabin intake duct. See Duct - Cabin Intake (Remove and
Replace).
Remove the hood latch cover. See Cover - Hood Latch (Remove and
Rep