Tesla Model 3: High Voltage System
Tesla Model 3 2017-2026 Service Manual / High Voltage System
- Charge System Inlet
- Carrier Assembly - Charge Port (Remove and Replace)
- Charge Port - Manual Release of Cable
- Charge Port Voltage Check
- Deadfronts - Pin - Charge Port (NA) (Remove and Replace)
- Door and Hinge Cover - Charge Port (Remove and Replace)
- Door Assembly - Charge Port (NA) (Remove and Replace)
- Door Assembly - Charge Port (China) (Remove and Replace)
- ECU - Charge Port (Remove and Replace)
- Latch Actuator - Charge Port (Remove and Replace)
- HV Harnesses
READ NEXT:
Carrier Assembly - Charge Port (Remove and Replace)
Carrier Assembly - Charge Port - Remove
SPECIAL TOOLS
Insulation Multimeter, Fluke 1507 (NA)
(1076921-00-B)
SEE MORE:
Latch - Door - Front - LH (Remove and Replace)
Remove
Remove the front LH door closeout panel. See Closeout Panel - Door -
Front - LH (Remove and Install).
Disconnect the electrical harness from the door latch connector.
Subframe Assembly - Front (RWD) (Remove and Replace)
Caution:
Vehicles built before March 25th, 2019 have 1st generation front
subframes. Vehicles built on March 25th, 2019 and after have 2nd generation
front subframes. When a 1st generation subframe is replaced with a 2nd
generation subframe, the 1st generation (discontinued) steering rack, if
© 2019-2026 Copyright www.tmodel3.com
