Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Charge System Inlet

READ NEXT:

 Carrier Assembly - Charge Port (Remove and Replace)

Carrier Assembly - Charge Port - Remove   SPECIAL TOOLS Insulation Multimeter, Fluke 1507 (NA) (1076921-00-B)

SEE MORE:

 Condenser (Remove and Replace)

Remove Remove the cooling fan module. See Module - Cooling Fan (Remove and Install). Release the clips (x14) that attach the active grille shutter to the cooling fan module, and then remove the active grille shutter from the module. Remove the screws (x2) that attach the radiato

 General Fitting Instructions

Component Removal Whenever possible, clean components and surrounding area before removal. Cap off openings exposed by component removal. Immediately seal fuel, oil, or hydraulic lines when apertures are exposed; use plastic caps or plugs to prevent loss of fluid and ingress of dirt. Clo

© 2019-2026 Copyright www.tmodel3.com