Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Hub - Front - LH (Dual Motor) - Install

Install

  1. Use a magnetic field viewing card to check the LH front hub's tone ring.
  2. Line up the LH front drive unit halfshaft splines, and then install the LH front hub on the LH front knuckle.

Hub - Front - LH (Dual Motor) - Install

  1. Install the bolts that attach the LH front hub to the LH front knuckle. Torque 85 Nm

Hub - Front - LH (Dual Motor) - Install

  1. Install the LH front rotor on the LH front hub.

Hub - Front - LH (Dual Motor) - Install

  1. Install the new bolts that attach the LH front brake caliper to the LH front knuckle, and then remove the S-hook from the vehicle. Torque 94 Nm

Note: Mark the bolts with a paint pen

Hub - Front - LH (Dual Motor) - Install

  1. Install the bolt that attaches the front brake hose bracket to the LH front knuckle. Torque 5 Nm

Hub - Front - LH (Dual Motor) - Install

  1. Hand tighten a new front drive unit halfshaft nut on the front drive unit halfshaft.
  2. Install the LH front wheel and hand tighten the wheel lug nuts.
  3. Lower the vehicle until the tires are touching the ground. See Raise Vehicle - 2 Post Lift.
  4. Fully tighten the wheel lug nuts. See Wheel (Remove and Install).

Hub - Front - LH (Dual Motor) - Install

  1. Fully tighten the new LH front drive unit halfshaft nut. Torque 245 Nm
  2. If equipped, install the LH front wheel center cap. See Cap - Wheel (Remove and Replace).

    READ NEXT:

     Hub - Front - LH (RWD) (Remove and Replace)

    SPECIAL TOOLS Card, Magnetic Field Viewer (1062500-00-A) S-Hook (10821717-00-A) Remove Remove LH front wheel. See Wheel (Remove and Install). Remove the LH front brake rotor. See Brake Rotor -

     Knuckle - Suspension - Front - LH (Dual Motor) (Remove and Replace)

     Knuckle - Suspension - Front - LH (Dual Motor) - Remove

    Remove If equipped, remove the LH front wheel center cap. See Cap - Wheel (Remove and Replace). Loosen the LH front wheel lug nuts. Caution:  Use only hand tools to remove or install the

    SEE MORE:

     Starting and Powering Off

    Starting When you open a door, Model 3 powers on the touchscreen and you can operate all controls. To drive Model 3: PRESS THE BRAKE PEDAL - Model 3 powers on and is ready to drive. SELECT A GEAR - Move the gear lever all the way down for Drive and all the way up for Reverse. Not

     Steering Column - Remove

      Note: This procedure was formulated using a release candidate or production model. Follow safety requirements and use extreme caution when working on or near high-voltage systems and components. Remove

    © 2019-2024 Copyright www.tmodel3.com