Tesla Model 3: Knuckle - Suspension - Rear - LH - Remove
SPECIAL TOOLS
Tool, Spring Compressor, Hook, Model 3
(1135103-00-A)
Card, Magnetic Field Viewer (1062500-00-A)
Tool, Rear Ride Height Torque, Model 3
(1137855-00-A)
Remove
- Raise and support the vehicle. See Raise Vehicle - 2
Post Lift.
- Remove the LH rear wheel. See Wheel (Remove and
Install).
- Remove the LH rear wheel arch liner. See Wheel Arch
Liner - Rear - LH (Remove and Replace).
- Remove the LH rear brake rotor. See Brake Rotor -
Rear - LH (Remove and Replace).
- Remove the LH rear hub. See Hub - Rear - LH (Remove
and Replace).
- Remove the LH rear brake dust shield. See Shield -
Dust - Brake - Rear - LH (Remove and Replace).
- Remove the bolt that attaches the rear LH ABS wheel
speed sensor to the knuckle.
- Release the clip and remove the grommet that attach
the rear LH ABS wheel speed sensor cable to the rear
knuckle and bracket.
- Remove the LH rear suspension cover. See Cover -
Rear Suspension - LH (Remove and Replace).
- Install a spring compressor onto the LH rear coil
spring.
Note: Make sure that the spindle will go through
the body opening when the LH rear suspension is
compressed.
- Position a 3/4 ton support stand underneath the LH
rear suspension.
- Remove and discard the nut that attaches the LH sway
bar link to the LH rear suspension knuckle, and then
remove the link from the knuckle.
Note: Counter-hold the ball joint wih a 5 mm hex
wrench.
- Remove the bolt and nut that attach the LH rear
upper aft link to the LH rear suspension knuckle.
Torque 134 Nm
Torque 134 Nm
- Remove the bolt and nut that attach the LH rear
upper fore link to the LH rear suspension knuckle.
Torque 76 Nm
Torque 76 Nm
- Remove the bolt and nut that attach the LH toe link
to the LH rear suspension knuckle.
Torque 76 Nm
Torque 76 Nm
- Remove the bolt and nut that attach the LH rear
lower fore link to the LH rear suspension knuckle.
Torque 76 Nm
Torque 76 Nm
- Remove the bolt and nut that attach the LH rear aft
lower link to the LH rear suspension knuckle.
- Remove the LH rear suspension knuckle from the
vehicle.
READ NEXT:
Install
Position the LH rear suspension knuckle on the rear
suspension.
SPECIAL TOOLS
Tool, Spring Compressor, Hook, Model 3
(1135103-00-A)
Tool,
SEE MORE:
Install
Install a new secondary door seal on the replacement door. See Seal -
Secondary - Rear Door - LH (Remove and Replace).
Make sure that the upper bolt for each door hinge is installed, and the
bolt head extends approximately 10 mm from flush.
With assistance, lower the rear L
Using seat belts and child safety seats is the
most effective way to protect occupants if a
collision occurs. Therefore, wearing a seat belt
is required by law in most jurisdictions.
Both the driver and passenger seats are
equipped with three-point inertia reel seat
belts. Inertia reel belts