Tesla Model 3: Seal - Body - Side - Front - Primary - LH (Remove and Replace)
Remove
- Remove the LH B-pillar applique. See
Applique - B-Pillar - LH (Remove and Replace).
- Release the clips (x3) that attach the front LH primary body seal to the
mid B-pillar, the upper B-pillar, and the mid A-pillar.
- Pull on the seal to remove it from the body.
Install
- Loosely install the front LH primary body seal to the body.
- Fasten the clips (x3) that attach the front LH primary body seal to the
mid A-pillar, the upper B-pillar, and the mid B-pillar.
- Tuck the seal into the bright molding, and make sure that it fits
properly to the trim panels and the headliner.
- Press the seal into the lower corners, and then install the rest of the
seal to the body.
Note: Stretch and tuck the seal so that it is evenly distributed
around the perimeter
- Install the LH B-pillar applique. See
Applique - B-Pillar - LH (Remove and Replace).
READ NEXT:
Remove
Remove the LH B-pillar applique. See
Applique - B-Pillar - LH (Remove and Replace).
Release the clips (x3) that attach the rear LH primary body seal to the
mid B-pillar, the upper
Seal - Glass Run - Front Door - LH (Remove and Replace)- Remove
Remove
Remove the LH front door trim panel. See
Panel - Door Trim - Front - LH (Remove and Install).
Remove the LH front door inn
SEE MORE:
Inverter - Rear Drive Unit - Remove
SPECIAL TOOLS
Skt, 3/8in Dr, 10EP Torx Plus External (1130479-00-A)
Caution:
This procedure must not be used for replacement of
Remove the front passenger seat. See
Seat - Driver (Remove and Replace).
Remove the center console. See
Center Console (Remove and Install).
Release the clips that attach the RH front carpet to the vehicle, and
then remove the RH front carpet from the vehicle.
Install
Installation proc