Tesla Model 3: Stop Light and Stop Sign Warning (U.S. only)
Depending on market region or vehicle configuration, Stop Light and/or Stop Sign Warning may not be available on your vehicle.
While Autosteer is in use, Model 3 displays a warning on the touchscreen and sounds a chime if it detects that you are likely to run through a red stop light or stop sign. If this happens, TAKE IMMEDIATE CORRECTIVE ACTION! The visual and audible warnings cancel after a few seconds, or when you press the brake pedal, whichever comes first.
Note: Touch Controls > Autopilot > Full Self- Driving Visualization Preview to display more details about the roadway and its surroundings, such as road markings, stop signs, stop lights, objects (such as trash cans and poles), etc.
Caution: Stop Light and Stop Sign Warning require the vehicle's map to know that a particular stop light or stop sign exists in a certain location. It may be unaware of new stop lights or stop signs that are not captured in the map data.
Therefore, Stop Light and Stop Sign Warning may not detect all stop lights and stop signs due to potential map inaccuracies.
Warning: Stop Light and Stop Sign Warning do not apply the brakes or decelerate Model 3 and may not detect all stop lights and stop signs. Stop Light and Stop Sign Warning are designed for guidance purposes only and are not a substitute for attentive driving and sound judgment. Keep your eyes on the road when driving and never depend on Stop Light and Stop Sign Warning to warn you of a stop light or stop sign.
Warning: Stop Light and Stop Sign Warning are designed to only warn you when approaching a visible red stop sign, solid red or later portion of a yellow traffic light; it may not issue warnings at intersections with flashing lights and does not warn you of yield signs or temporary stop and yield signs (such as in construction areas). Additionally, Stop Light and Stop Sign Warning will not warn you of an approaching stop light or stop sign if you are pressing the accelerator pedal or brake pedal (which disables Autosteer).
READ NEXT:
Navigate on Autopilot
Note: Navigate on Autopilot is a BETA feature
and is not available in all market regions.
When using Autosteer on a controlled-access
road (such as a highway or freeway), Navigate
on Autopilot aut
Operating Navigate on Autopilot
Once enabled, the Navigate on Autopilot
button appears on the map's turn-by-turn
direction list whenever a navigation route is
active and the route includes at least one
controlled-access road. To
Lane Changes
Navigate on Autopilot changes lanes to either
prepare Model 3 for an upcoming off-ramp, to
increase your driving speed (not to exceed
your set cruising speed), or to move Model 3
out of a left-mos
SEE MORE:
Trim - C-Pillar - Rear - LH (Remove and Replace) - Install
Install
If reusing the same LH rear C-pillar trim, install new clips onto the
trim.
Move the seatbelt through the LH rear C-pillar trim.
Slide the seatbelt bezel onto the seat belt, and then fasten the bezel
clips that attach the seatbelt bezel to the LH rear C-pillar trim.
Instal
Visual and Audio Feedback
When you shift to Reverse, the Park Assist
view displays on the touchscreen, showing
objects that are in close proximity to the front
and rear of Model 3. This view closes when
you shift into Drive unless an object is
detected close to the front of Model 3, in
which case the Park Assist view c
