Motors
| Type, Rear | Permanent Magnet Synchronous Motor, liquid-cooled |
| Nominal Voltage | 350 V |
| Maximum net power and engine speed of rear motor Note: Tested in accordance with ECE R85. |
Long Range - 202 kW |
| Maximum torque of rear motor | Long Range - 416 Nm |
Suspension
| Front | Independent. Upper wishbone with lower unequal length control arms. Co-axial coil spring/telescopic damper. Sway bar. |
| Ride height | See Wheel Alignment. |
| Rear | Independent. Dual upper arms and lower unequal length wishbone. Co-axial coil spring/telescopic damper. |
Wheel Alignment
Note: All specifications given in degrees. To convert from degrees to minutes and seconds, multiple the decimal after the whole number by 60. The whole number becomes the minute. Take the remaining decimal and multiply it by 60 to get the second. For example, 1.75º would be 1º and 45 min (.75*60). 0.17º would be 10 min and 12 seconds. (0.17*60=10.2; .2*60=12).
Table 1. Coil Suspension vehicles.
| Location | Front | Rear |
|---|---|---|
| Camber | -0.50º +/- 0.45º | -1.00º +/- 1.0º |
| Camber Split | +/- 0.60º | +/- 0.80º |
| Caster | 5.70º +/- 1.0º | Not applicable |
| Caster Split | +/- 1.0º | Not applicable |
| Individual Toe | OUT 0.05º +/- 0.15º | IN 0.20º +/- 0.15º |
| Toe Split | +/- 0.10º | +/- 0.10º |
| Track Width (at wheel center height) | 1580 mm | 1580 mm |
| Non-Performance Coil Ride
Height (unladen)
Note: When measuring the coil ride height, measure 75 mm inward
from the ski hole in each corner of the Battery. See the image
below.
|
153 +/- 5 mm | 157 +/- 5 mm |
| Performance Coil Ride Height
(unladen)
Note: When measuring the coil ride height, measure 75 mm inward
from the ski hole in each corner of the Battery. See the image
below.
|
151 +/- 3 mm | 155 +/- 3 mm |
| Wheelbase | 2875 mm | |

Location for measuring coil ride height
Brakes
Table 1. Rotor diameter (ventilated)
| Size (inches) | Size (millimeters) | |
|---|---|---|
| Front | 12.6 | 320 |
| Rear | 13.2 | 335 |
Table 2. Front rotor thickness
| Size (inches) | Size (millimeters) | |
|---|---|---|
| New | .98 | 25 |
| Service limit | .91 | 23 |
Table 3. Rear rotor thickness
|
|
Size (inches) |
Size (millimeters) |
|---|---|---|
| New | .79 | 20 |
| Service limit | .71 | 18 |
Table 4. Front brake pad thickness (excluding backing plate)
| Size (inches) | Size (millimeters) | |
|---|---|---|
| New | .393 | 20 |
| Service limit | .110 | 18 |
Table 5. Rear brake pad thickness (excluding backing plate)
| Size (inches) | Size (millimeters) | |
|---|---|---|
| New | .354 | 9 |
| Service limit | .078 | 2 |
Table 6. Electronic parking brake (EPB) brake pad thickness (excluding backing plate)
| Size (inches) | Size (millimeters) | |
|---|---|---|
| Parking brake (EPB) | Electrically actuated parking brake integrated into the rear caliper. | |
Wheels
Lug Nut Torque: 175 Nm (129 lb. ft.)
Lug Nut Socket Size: 21 mm
Note: Wheel package availability varies by region.
| Wheel Diameter | Location | Width (in) | Offset (mm) |
|---|---|---|---|
| 18" | Front/Rear | 8.5 | 40 |
| 19" | Front/Rear | 8.5 | 40 |
| 20" (non-Performance brakes) | Front/Rear | 8.5 | 40 |
| 20" (Performance brakes) | Front/Rear | 8.5 | 35 |
Tire Pressures
|
Tire |
Pressure |
|---|---|
|
18 in |
Refer to the "Tire and Loading Information" label located on the driver side B-pillar. |
|
19 in |
Refer to the "Tire and Loading Information" label located on the driver side B-pillar. |
|
20 in |
Refer to the "Tire and Loading Information" label located on the driver side B-pillar. |
Electrical
Table 1. Battery - High Voltage
|
System |
Rechargeable Battery System |
|---|---|
|
Type |
Lithium ion (Li-ion) |
|
Voltage |
370 Nominal |
|
Internal Operating Temperature |
Driving: -22º F to 140º F (-30º C to 60º C) |
|
Degrees |
Charging: 32º F to 113º F (0º C to 45º C) |
Table 2. Battery - 12V
|
System |
Rechargeable Battery System |
|---|---|
|
Rating |
Above 45 Amp/hr |
|
Voltage and Polarity |
12V Negative (-) ground |
Vehicle Identification Number (VIN)
Serial Numbers
Tweeter - Dash (Remove and Replace)
Spring and Damper Assembly - Front - LH (Remove and Replace)