Tesla Model 3: Badges and Films
Tesla Model 3 2017-2026 Service Manual / Exterior Fittings / Badges and Films
- Rear Lettering (Retrofit)
- Tesla Badge - Front (Remove and Replace)
- Tesla Badge - Rear (Remove and Replace)
READ NEXT:
Rear Lettering (Retrofit)
SPECIAL TOOLS
Fixture, Badge, Dual Motor/Perf, M3 (1475764-00-A)
Seam Roller, Silicone, 5" (1049517-00-A)
Procedure
Clean the trunk area where the "Dual Motor" badge is to be installed
with an
Tesla Badge - Front (Remove and Replace)
SPECIAL TOOLS
Kit, Badge Removal (1453028-00-A)
Fixture, Front Badge, Model 3 (1134702-00-A)
Remove
Prepare the badge removal tool with approximately 60 centimeters of
monofilament line.
With
Tesla Badge - Rear (Remove and Replace)
SPECIAL TOOLS
Kit, Badge Removal (1453028-00-A)
Fixture, Rear Badge, Model 3 (1134703-00-A)
Remove
Prepare the badge removal tool with approximately 60 centimeters of
monofilament line.
Raise
SEE MORE:
Light - Fog / Reverse - Rear - LH (Remove and Replace)
Remove
Remove the trunk lid trim. See Trim - Lid - Trunk (Remove and Replace).
Disconnect the electrical wiring harness connector from the LH rear fog/reverse
light.
Remove the nut that attaches the LH rear fog/reverse light to the trunk
lid.
Torque 3.2 Nm
Remove the LH rea
Door Assembly - Charge Port (China) (Remove and Replace)
Door Assembly - Charge Port (China) - Remove
SPECIAL TOOLS
Insulation Multimeter, Fluke 1508 (1076921-01-B)
Test Probes, Slim, Fluke TP38 (1130480-00-A)
© 2019-2026 Copyright www.tmodel3.com
