Tesla Model 3: Exterior Mirrors
Tesla Model 3 2017-2026 Service Manual / Exterior Fittings / Exterior Mirrors
READ NEXT:
Mirror - Door - LH (Remove and Replace)
Remove
Use a plastic trim tool to pry up along the inner edge of the mirror
cover.
Lift upward to release the tabs that attach the mirror cover to the LH
door mirror, and then remove
Skull Cap - Door Mirror - LH (Remove and Replace)
Remove
Outside Edge of Skull Cap
Inside Edge of Skull Cap
Pull outward to release the clips that attach the rear of the LH door
mirror skull cap to the LH door mirror.
Pry up along the
SEE MORE:
Solenoid - Glove Box (Remove and Replace)
Remove
Remove the glove box. See
Glove Box (LHD) (Remove and Replace).
Remove and discard the NVH pad from the glove box.
Note: The NVH pad is one time use only.
Release the clips that attach the glove box solenoid electrical harness
to the glove box.
Remove the bolts that
Vehicle Electrical Isolation Procedure
SPECIAL TOOLS
Insulation Multimeter, Fluke 1507 (1076921-00-B)
Test Probes, Slim, Fluke TP38 (1130480-00-A)
Warning: This procedure verifies that high voltage power is no
longer available to high voltage components (PTC heater, A/C compressor,
inverters, etc). Perform this procedure before servici
© 2019-2026 Copyright www.tmodel3.com
