Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Front Cameras

READ NEXT:

 Forward Facing (Remove and Replace)

Remove Remove the rear view mirror. See Mirror - Rear View (Remove and Replace). Release the clips that attach the mirror front cover to the windshield bracket, and then separate the cover

 Forward Facing (Target Calibration)

SPECIAL TOOLS Camera Calibration Target (1053066-00-A) Wrench, 2.5mm, Thin (1448868-00-A) Note: This procedure describes how to calibrate the forward facing cameras. It does not apply to the rear f

 Interior Camera

Camera - Occupant (Remove and Replace) Remove Remove the rear view mirror. See Mirror - Rear View (Remove and Replace). Release the clips that attach the upper quad camera cover, disconnect

SEE MORE:

 Hall Sensor - Exterior Release - Door - Front - LH (Remove and Replace)

Remove Remove the LH front door trim panel. See Panel - Door Trim - Front - LH (Remove and Install). Remove the LH front door inner belt seal. See Seal - Inner Belt - Front Door - LH (Remove and Replace). Remove the front LH door glass. See Glass - Door - LH - Front (Remove and Replace)

 Seal - Secondary - Front Door - LH (Remove and Replace)

Remove Open the LH front door. Use narrow-width tape to carefully mark the location of the secondary seal around the door. Caution: Make sure that the edge of the tape accurately follows the edge of the seal. Release the ends of the door secondary seal from the rear of the inner be

© 2019-2026 Copyright www.tmodel3.com