Tesla Model 3: Inspection and Service
Maintenance Service
Maintenance Service and Intervals
Note: Use this information to determine the maintenance procedures and intervals that Tesla recommends.
Brake Fluid Check
Check the condition of the brake fluid every 2 years.
Brake Fluid Flush
Perform the brake fluid flush when the brake fluid check indicates that the brake fluid needs to be replaced. See Brake Fluid Bleed / Flush.
A/C Desiccant Bag Replacement
Replace the A/C desiccant bag every 6 years. See Receiver Dryer and Desiccant (Remove and Replace).
Cabin Air Filter Replacement
Replace the cabin air filter every 2 years for all countries except China. In China, recommended replacement is every year. See Filter - Cabin (Remove and Replace).
Tire Rotation
Rotate the tires at 2/32 in. (1.5 mm) or greater depth difference. Tire rotation might not be applicable on vehicles equipped with staggered wheel fitment or directional tires. See Tire Rotation..
Wheel Alignment Check
Perform a wheel alignment check if tires are wearing unevenly or customer complaints that the vehicle is pulling. See Four Wheel Alignment (Check).
Clean and Lubricate Brake Calipers
Clean and lubricate the brake caliper pad slides every year only for cold weather regions or areas where road salt is used.
READ NEXT:
Raise Vehicle - 2 Post Lift
DRAFT
Warning:
This procedure was derived from pre-production computer
models, and might not reflect the real-world situation. Warnings and cautions
might be missing. Follow safety requirements a
SEE MORE:
Hinge - Hood - LH (Remove and Replace)
Remove
Remove the rear underhood apron. See Underhood Apron - Rear (Remove and
Replace).
Remove the cabin intake duct. See Duct - Cabin Intake (Remove and
Replace).
Remove the hood latch cover. See Cover - Hood Latch (Remove and
Replace).
Remove the underhood storage unit. See Underhoo
Sensor - Temperature - LH (Remove and Replace)
Remove
Remove the driver floormat.
Remove the center console LH side carpet. See
Carpet - Side Panel - Center Console - LH (Remove and Replace).
Disconnect the LH temperature sensor electrical connector.
Release the tabs that attach the LH temperature sensor inside the HVAC
assembl
