Tesla Model 3: Actuator - Vent - RH (Remove and Replace)
Tesla Model 3 2017-2026 Service Manual / Thermal Management / Cabin HVAC / Actuator - Vent - RH (Remove and Replace)
Remove
- Remove the RH front vent. See Vent - Front - RH (Remove and Replace).
- Remove the screws that attach the RH vent actuator to the RH front vent,
and then remove the actuator from the vent.
Torque 1.3 Nm
Install
Installation procedure is the reverse of removal.
READ NEXT:
Air Extractor - LH (Remove and Replace)
Remove
Remove the rear fascia. See
Fascia - Rear (Remove and Install).
Press downward at the top to release the tabs that attach the air
extractor to the body, then swing the upper portion
Duct - Air Wave - LH (Remove and Replace)
Remove
Remove the IP carrier. See
IP Carrier (Remove and Replace).
Remove the screws (x2) that attach the LH air wave duct to the cross bar
beam, and then remove the duct from the vehicle.
Duct - Air Wave - RH (Remove and Replace)
Remove
Remove the glove box. See
Glove Box (LHD) (Remove and Replace).
Remove the RH footwell air duct from the HVAC module, and then remove
the duct from the vehicle.
Release the cli
SEE MORE:
Pressure Transducer - High Pressure (Remove and Replace)
Remove
Remove the underhood storage unit. See Underhood Storage Unit (Remove
and Replace).
Perform the A/C refrigerant recovery. See A/C Refrigerant (Recovery and
Recharge).
Remove the outer HVAC plenum duct. See Duct - HVAC Plenum - Outer
(Remove and Replace).
Disconnect the electrical
Switch - Exterior Release - Trunk (Remove and Replace)
Remove
Remove the trunk lid trim. See Trim - Lid - Trunk (Remove and Replace).
Disconnect the electrical connectors from the trunk exterior release
switch and the rear facing camera.
Remove the bolts that attach the rear facing camera to the trunk
exterior release switch, and
© 2019-2026 Copyright www.tmodel3.com
