Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Cabin HVAC

Tesla Model 3 2017-2026 Service Manual / Thermal Management / Cabin HVAC

READ NEXT:

 Actuator - Bleed - LH (Remove and Replace)

Remove Remove the cross car beam. See Beam - Cross Car (Remove and Replace). Disconnect the electrical wiring harness connector from the LH bleed actuator. Remove the bolts that attac

 Actuator - Intake (Remove and Replace)

Remove Remove the HVAC assembly. See HVAC Assembly (Remove and Replace). Disconnect the electrical harness from the intake actuator connector. Remove the screws (x2) that attach the int

 Actuator - Lower Mode (Remove and Replace)

Remove Remove the HVAC assembly. See HVAC Assembly (Remove and Replace). Disconnect the lower mode actuator electrical connector. Remove the screws that attach the lower mode actuator t

SEE MORE:

 Tweeter - Dash (Remove and Replace)

Remove Remove the LH and RH instrument panel end caps. See End Cap - Instrument Panel - LH (Remove and Replace). Remove the LH and RH mid A-pillar trims. See Trim - A-Pillar - Middle - LH (Remove and Replace). Remove the LH and RH upper A-pillar trims. See Trim - A-Pillar - Upper - LH (R

 12V Power (Disconnect and Connect)

12V Power- Disconnect SPECIAL TOOLS Cap, Logic Conn, Inv, 3DU (1108272-00-B) Warning: This procedure disables 12V power, but does not verify that high voltage power is no longer available to high voltage components (PTC heater, A/C compressor, inverters, etc). Perform Vehicle Electrical Isolati

© 2019-2026 Copyright www.tmodel3.com