Tesla Model 3: Blower Motor - HVAC (Remove and Replace)

Remove
- Remove the HVAC assembly. See
HVAC Assembly (Remove and Replace).

- Remove the screws that attach the HVAC fan motor to the HVAC assembly,
and then remove the motor from the HVAC assembly.

Install
- Position the HVAC fan motor on the HVAC assembly.

- Install the screws that attach the HVAC fan motor to the HVAC assembly.
Torque 1.2 Nm
- Install the HVAC assembly. See
HVAC Assembly (Remove and Replace).
READ NEXT:
Remove
Remove the front fascia. See
Fascia - Front (Remove and Install).
Disconnect the electrical harness from the ambient air temperature
sensor connector.
Release the clip that attac
Note: This procedure was formulated using a release candidate
or production model. Follow safety requirements and use extreme caution when
working on or near high-voltage systems and compone
Remove
Remove the driver floormat.
Remove the LH center console side panel carpet. See
Carpet - Side Panel - Center Console - LH (Remove and Replace).
Disconnect the evaporator temperature
SEE MORE:
SPECIAL TOOLS
Flare nut crowfoot set (1079041-00-A)
Kit, EPB Release, Handheld (1134520-00-A)
Remove
Remove the LH center console side panel carpet. See Carpet - Side Panel
- Center Console - LH (Remove and Replace).
Disconnect 12V power. See 12V Power (Disconnect and Connect).
Remove the driver footwell cover. See Cover - Footwell - Driver (Remove
and Replace).
Remove the T20