Tesla Model 3: Sensor - Ambient Air Temperature (Remove and Replace)
Remove
- Remove the front fascia. See
Fascia - Front (Remove and Install).

- Disconnect the electrical harness from the ambient air temperature
sensor connector.

- Release the clip that attaches the ambient air temperature sensor to the
lower grille, and then remove the sensor from the lower grille.
Note: Press the tab that attaches the ambient air
temperature sensor and slide up to remove it from the lower grille.
Install
Installation procedure is the reverse of removal.
READ NEXT:
Note: This procedure was formulated using a release candidate
or production model. Follow safety requirements and use extreme caution when
working on or near high-voltage systems and compone
Remove
Remove the driver floormat.
Remove the LH center console side panel carpet. See
Carpet - Side Panel - Center Console - LH (Remove and Replace).
Disconnect the evaporator temperature
Remove
Remove the driver floormat.
Remove the center console LH side carpet. See
Carpet - Side Panel - Center Console - LH (Remove and Replace).
Disconnect the LH temperature sensor electri
SEE MORE:
Remove
Remove the HVAC assembly. See
HVAC Assembly (Remove and Replace).
Disconnect the electrical harness from the intake actuator connector.
Remove the screws (x2) that attach the intake actuator to the HVAC
module, and then remove the actuator from the HVAC module.
Torque 1.2 N
Remove
Remove the rear underhood apron. See
Underhood Apron - Rear (Remove and Replace).
Remove the cabin intake duct. See
Duct - Cabin Intake (Remove and Replace).
Remove the hood latch cover. See
Cover - Hood Latch (Remove and Replace).
Remove the underhood storage unit carpet. See
Car