Tesla Model 3: Duct - Cabin Intake (Remove and Replace)
Tesla Model 3 2017-2026 Service Manual / Thermal Management / Cabin HVAC / Duct - Cabin Intake (Remove and Replace)
Remove
- Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
- Release the clips (x4) that attach the cabin intake duct to the cowl
screen panel, and then remove the duct from the vehicle.
Install
Installation procedure is the reverse of removal.
READ NEXT:
Duct - Footwell - LH (Remove and Replace)
Remove
Remove the LH center console side panel carpet. See
Carpet - Side Panel - Center Console - LH (Remove and Replace).
Disconnect 12V power. See
12V Power (Disconnect and Connect).
Remove
Duct - Footwell - RH (Remove and Replace)
DRAFT
Warning:
This procedure was derived from pre-production computer models, and
might not reflect the real-world situation. Warnings and cautions might be
missing. Follow safety requirements a
Duct - HVAC Plenum - Inner (Remove and Replace)
Remove
Remove the rear underhood apron. See
Underhood Apron - Rear (Remove and Replace).
Remove the outer HVAC plenum. See
Duct - HVAC Plenum - Outer (Remove and Replace).
Remove the hood latc
SEE MORE:
Ski - Center Rail - HV Battery (RWD) (Remove and Replace)
Ski - Center Rail - HV Battery (RWD) - Remove
SPECIAL TOOLS
Lever Lock, HV Connector, Model 3 (1140311-00-A)
Warning:
Only technicians who have been trained in High Voltage Awareness are
permitted to perform this procedure. Proper personal protective equipment (PPE)
and insulating HV gloves with
Seal - Secondary - Front Door - LH (Remove and Replace)
Remove
Open the LH front door.
Use narrow-width tape to carefully mark the location of the secondary
seal around the door.
Caution:
Make sure that the edge of the tape accurately follows the edge of the
seal.
Release the ends of the door secondary seal from the rear of the inner
be
© 2019-2026 Copyright www.tmodel3.com
