Tesla Model 3: Body
- Vehicle Lifting
- Bumper / Fascia
- Ankle Catcher (Remove and Replace)
- Bracket - Fascia Side to Fender - LH (Remove and Replace)
- Bracket - Rear - Center (Remove and Replace)
- Bracket - Rear Wing - LH (Remove and Replace)
- Bracket - Taillight - LH (Remove and Replace)
- Bumper - Front (Remove and Replace)
- Bumper - Rear (Remove and Replace)
- Cover - Tow Hook (Remove and Replace)
- Crush Can - Front - LH (Remove and Replace)
- Fascia - Front (Remove and Install)
- Fascia - Front (Remove and Replace)
- Fascia - Rear (Remove and Install)
- Fascia - Rear - Lower (Remove and Replace)
- Fascia - Rear - Upper (Remove and Replace)
- Grille - Fascia - Front (Remove and Replace)
- Valance - Front Fascia (Remove and Replace)
- Body Panels
- Brace - Shock Tower (Remove and Replace)
- Bracket - Crash Can - LH (Remove and Replace)
- Carrier - Front End (Remove and Replace)
- Door - Front - LH (Remove and Install)
- Door - Front - LH (Remove and Replace)
- Door - Rear - LH (Remove and Install)
- Door - Rear - LH (Remove and Replace)
- Fender Assembly - Front - LH (Remove and Replace)
- Hood (Remove and Install)
- Hood (Remove and Replace)
- Trunk (Remove and Install)
- Trunk (Remove and Replace)
- Windshield and Body Glass
- Glass - Backlight (Remove and Replace)
- Glass - Body - Rear Quarter - LH (Remove and Replace)
- Glass - Roof - Fixed (Remove and Replace)
- Sensor - Relative Humidity and Temperature (Remove and Replace)
- Windshield (Remove and Install)
- Windshield (Remove and Replace)
- Paint
READ NEXT:
Raise Vehicle - 2 Post Lift
DRAFT
Warning:
This procedure was derived from pre-production computer
models, and might not reflect the real-world situation. Warnings and cautions
might be missing. Follow safety requirements a
Raise Vehicle - 4 Post Lift
DRAFT
Warning:
This procedure was derived from pre-production computer models, and
might not reflect the real-world situation. Warnings and cautions might be
missing. Follow safety requirements and
SEE MORE:
Fluid Reservoirs
Removing the Maintenance Panel
To check fluid levels, remove the maintenance
panel:
Open the hood.
Pull the maintenance panel upward to
release the clips that hold it in place.
If checking the Battery coolant, remove
the cabin intake trim panel by pulling it
upwards to r
Switch - Steering Wheel - RH (Remove and Replace)
Remove the driver airbag. See Airbag - Driver (Remove and Replace).
Disconnect the steering wheel electrical wiring harness from the
connector.
Disconnect the electrical harness from the LH steering wheel switch
connector.
Disconnect the electrical harness from the RH steering
© 2019-2026 Copyright www.tmodel3.com
