Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Paint

Tesla Model 3 2017-2026 Service Manual / Body / Paint

READ NEXT:

 Paint Defect Rectification

Note: This procedure was designed to be performed on flat or near-flat metal body panels with original factory paintwork. Any deviation from these circumstances can alter cutting times, tool speeds,

 Remove Dirt Inclusion

Apply isopropyl alcohol to the general area of the defect, and then wipe the area with a clean microfiber towel. While wearing a nitrile glove, run hand over the area around the dirt inclu

 Polish

Remove the cutting pad from the buffer, and then install a polishing pad on the buffer. Apply 4 evenly spaced 20 mm diameter dollops of polishing compound on the polishing pad. Set the buffer speed

SEE MORE:

 Seal - Body - Side - Rear - Primary - LH (Remove and Replace)

Remove Remove the LH B-pillar applique. See Applique - B-Pillar - LH (Remove and Replace). Release the clips (x3) that attach the rear LH primary body seal to the mid B-pillar, the upper B-pillar, and the mid C-pillar. Pull on the seal to remove it from the body. Install Loosely

 Link - Compliance - Lower - Front - LH (Remove and Replace)

Remove Remove the LH front wheel arch liner. See Wheel Arch Liner - Front - LH (Remove and Replace). Remove the front aero shield panel. See Panel - Aero Shield - Front (Remove and Replace). Remove and discard the nut that attaches the front LH lower compliance link to the knuckle.

© 2019-2026 Copyright www.tmodel3.com