Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Bumper / Fascia

READ NEXT:

 Ankle Catcher (Remove and Replace)

Remove Remove the front fascia. Remove the bolts that attach the bottom of the cooling fan module to the ankle catcher Note: Lift the condenser fan module up to ease removal of the bolts.

 Bracket - Fascia Side to Fender - LH (Remove and Replace)

Remove LH shown, RH similar; one clip is behind the knuckle Remove the LH and RH front wheels. Release the clips (x9) that attach the front portion of the LH wheel arch liner to the vehicle,

 Bracket - Rear - Center (Remove and Replace)

Remove Remove the rear fascia. Release the clips that attach the rear Bluetooth passive entry antenna electrical harness to the center rear bracket assembly. Remove rear Bluetooth pass

SEE MORE:

 Ground Strap - Front Drive Unit (Remove and Replace)

Remove Raise and support the vehicle. See Raise Vehicle - 2 Post Lift. Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace). Remove the rear underhood apron. See Underhood Apron

 Fluid Reservoirs

Removing the Maintenance Panel To check fluid levels, remove the maintenance panel: Open the hood.  Pull the maintenance panel upward to release the clips that hold it in place. If checking the Battery coolant, remove the cabin intake trim panel by pulling it upwards to r

© 2019-2026 Copyright www.tmodel3.com