Tesla Model 3: Puddle Light - Front Door - LH (Remove and Replace)

Remove
.png)
- Use a small screwdriver or pry tool in the slot at the front of the
puddle light to pry the light out of the bottom of the front LH door trim
panel.

- Release the clips that attach the front of the puddle light to the
bottom of the door trim panel, and then separate the light from the panel.
Caution: Do not pull the puddle light too far from the door panel, as
the puddle light connector is still attached.

- Disconnect the electrical wiring harness from the puddle light connector,
and then remove the light from the vehicle.
Install
Installation procedure is the reverse of removal, except for the following:
Align the slot of the light toward the front of the vehicle
READ NEXT:
Remove
Use a small screwdriver or pry tool in the slot at the front of the
puddle light to pry the light out of the bottom of the rear LH door trim
panel.
Release the clips that attach
ECU - Headlight - Remove
Remove
Raise and support the vehicle. See Raise Vehicle - 2 Post Lift.
Remove the rear underhood apron. See Underhood Apron - Rear (Remove and
Replace).
Remove the cab
SEE MORE:
SPECIAL TOOLS
Wheel Trim Removal Tool (1044206-00-A)
Remove
Remove the wheel cap according to the type of wheel.
18 inch pinwheel wheel: See step
2
19 inch stiletto wheel: See step
3
Gently pull the wheel cap with both hands to release the clips that
attach the wheel cap to the wh
Raise and support the vehicle. See Raise Vehicle - 2
Post Lift.
Remove the LH front wheel. See Wheel (Remove and
Install).