Tesla Model 3: Exterior Lights
Tesla Model 3 2017-2026 Service Manual / Electrical / Exterior Lights
- ECU - Headlight (Remove and Replace)
- Headlights - Adjust - EMEA (Wall Method)
- Headlights - Adjust - NA (Tool Method)
- Headlights - Adjust - NA (Wall Method)
- Headlight - LH (Remove and Replace)
- Light - Brake - High Mounted (Remove and Replace)
- Light - Fog - Front (Adjust)
- Light - Fog / Reverse - Rear - LH (Remove and Replace)
- Light - License Plate (Remove and Replace)
- Light - Side Repeater - Front - LH (Remove and Replace)
- Light - Turn Signal / Fog - Front - LH (Remove and Replace)
- Taillight - LH (Remove and Replace)
- Reflex Lens - Rear - RH (Remove and Replace)
- Reflector - Fascia - Rear - LH (Remove and Replace)
READ NEXT:
ECU - Headlight (Remove and Replace)
ECU - Headlight - Remove
Remove
Raise and support the vehicle. See Raise Vehicle - 2 Post Lift.
Remove the rear underhood apron. See Underhood Apron - Rear (Remove and
Replace).
Remove the cab
SEE MORE:
Seal - Inner Belt - Front Door - LH (Remove and Replace)
Remove
Remove the LH front door trim panel. See
Panel - Door Trim - Front - LH (Remove and Replace).
Remove the rear of the inner belt seal from the door.
Release the rest of the seal from the door, and then remove the seal
from the door.
Install
Installation procedure is the rever
Valance - Front Fascia (Remove and Replace)
Remove
Remove the front aero shield panel.
Release the clips (x2) that attach the valance to the stabilizer bar
brackets.
Remove the push clips (x4) that attach the LH and RH sides of the
valance to the wheel liners.
Note: Remove the outer clips as necessary to allow for easier
ac
© 2019-2026 Copyright www.tmodel3.com
