Tesla Model 3: Light - License Plate (Remove and Replace)

Remove
.jpg)
- Remove the trunk lid trim. See Trim - Lid - Trunk (Remove and Replace).
- Disconnect the electrical connector from the license plate light.


- Push the license plate light towards the RH of the vehicle to compress
the clip, and then compress the clip on the other side of the light to
remove the light.


Install
Installation procedure is the reverse of removal.
READ NEXT:
Remove
Raise and support the vehicle. See Raise Vehicle - 2 Post Lift.
Apply protective tape to the LH fender around the front side repeater
light.
Remove the LH front wheel. See Wheel (Remove
Remove
Remove the LH front wheel. See
Wheel (Remove and Install).
Remove the LH front wheel arch liner. See
Wheel Arch Liner - Front - LH (Remove and Replace).
Disconnect the electrical conn
Taillight - LH- Remove
SPECIAL TOOLS
SKT, BUMP STOP, MDL 3 (1460222-00-B)
Remove
Remove the 2nd row lower seat cushion. See
Seat Cushion - Lower - 2nd Row (Remove and Replace).
Open the trunk,
SEE MORE:
Remove
Remove the RH 2nd row seat back. See
Seat Back - 2nd Row - RH (Remove and Install).
Remove the RH side trunk carpet clips (x2) from the body studs located
under the 2nd row seat cushion.
Raise the trunk carpet over the ISOFIX bars on the RH side.
Remove the trunk sill tri
Remove
Open the trunk.
Lift up the rear trunk floor, and then remove it from the vehicle.
Remove the trunk sill trim. See
Trim - Sill - Trunk (Remove and Replace).
Release the trunk seal from the trunk perimeter, and then remove the
seal from the body.
Install
Install the trunk