Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Radar Sensors

READ NEXT:

 Sensor - Radar - Front (Calibration)

Calibrate Perform a 4-wheel alignment. See Four Wheel Alignment (Check and Adjust). Connect a laptop with Toolbox to the vehicle. With an assistant, use Toolbox to perform a radar drive cycle

 Sensor - Radar - Front (Remove and Replace)

Remove Remove the front fascia. See Fascia - Front (Remove and Install). Release the clip that attaches the front radar sensor wiring harness to the front end carrier. Disconnect the e

 Front Cameras

SEE MORE:

 Tesla Badge - Rear (Remove and Replace)

SPECIAL TOOLS Kit, Badge Removal (1453028-00-A) Fixture, Rear Badge, Model 3 (1134703-00-A) Remove Prepare the badge removal tool with approximately 60 centimeters of monofilament line. Raise the trunk lid, and position the badge removal tool so that the monofilament line cuts under a corn

 Easter Eggs

But wait, there's more! Below is a list of the Easter Eggs that have been discovered so far and how to access them. Alternatively, touch the Tesla "T" (top center of the touchscreen) then drag the About Your Tesla box downwards for one-touch access to all discovered Easter Eggs

© 2019-2026 Copyright www.tmodel3.com