Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Switch - Window - Rear (Remove and Replace)

Tesla Model 3 2017-2026 Service Manual / Closures / Door Glass and Regulators / Switch - Window - Rear (Remove and Replace)

Remove

  1. Remove the LH rear door trim panel. See Panel - Door Trim - Rear - LH (Remove and Install).
  1. Release the clips that attach the rear window switch to the door trim panel.

  Tip: Release the front clips first, and then release the rear clips while pushing the rear window switch to release it from the door trim panel.

Note: Feed the electrical harness through the door trim panel hole to remove the electrical harness from the rear window switch.

Note: Replace any broken door panel clips

  1. Remove the rear window switch from the vehicle.

Install

  1. Install the electrical harness connector to the rear window switch.
  2. Secure the clips that attach the rear window switch to the door trim panel.
  3. Install the LH rear door trim panel. See Panel - Door Trim - Rear - LH (Remove and Install).

    READ NEXT:

     Window Motor / Regulator Assembly - Front - LH (Remove and Replace)

    Warning: The side impact airbag deployment depends on the front door sensor's ability to detect a side impact from air pressure. Make sure that there are no uncovered holes in the front door shells.

     Window Motor / Regulator Assembly - Rear - LH (Remove and Replace)

    SPECIAL TOOLS Rivnut Install Kit, for NA (1054712-00-A )Rivnut Install Kit, for EMEA (1054712-01-A ) Service rivnut (1004296-00-A)Service bolt (1015888-00-C) Warning: The side impact airbag deploym

     Window Regulator - Front - LH (Recalibrate)

    Connect a laptop with Toolbox to the vehicle. In Toolbox, select the connection status icon at the top right corner, and then select Connect Locally. Get into the driver seat, and then close the

    SEE MORE:

     Sensor - TPMS (Remove and Replace)

        Remove Remove the wheel. See Wheel (Remove and Install). Place the wheel on the tire changer, with the outside of the wheel facing up. Insert the center cl

     Brake Rotor - Rear - LH (Remove and Replace)

    SPECIAL TOOLS Tool, Caliper Spreader, Model 3 (1134786-00-A) Remove Raise the vehicle and remove the LH rear wheel. See Wheel (Remove and Install). Use Toolbox to place the vehicle into EPB Service Mode. See Release Parking Brake Using Toolbox Disconnect the electrical wiring harness con

    © 2019-2026 Copyright www.tmodel3.com