Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Window Regulator - Front - LH (Recalibrate)

Tesla Model 3 2017-2025 Service Manual / Closures / Door Glass and Regulators / Window Regulator - Front - LH (Recalibrate)

  1. Connect a laptop with Toolbox to the vehicle.
  2. In Toolbox, select the connection status icon at the top right corner, and then select Connect Locally.
  3. Get into the driver seat, and then close the door.
  4. In Toolbox, type window in the search field.

Note: Make sure that "Actions" is selected, if not already

  1. In Toolbox, click the play button next to the "TESTSELF_ VCLEFT_FRONT-L_CALIBRATE-WINDOW", and then click Run.

Note:When selecting this function in Toolbox, the LH front window rolls up, and then it rolls down

Press the LH front window switch down to the second position to activate the auto-lower function, and then raise the window completely to active the auto-raise function.

Note: If the LH front window does not lower completely, repeat steps 3 through 5

  1. Remove the laptop from the vehicle.

    READ NEXT:

     Window Regulator - Rear - LH (Recalibrate)

    Connect a laptop with Toolbox to the vehicle. In Toolbox, select the connection status icon at the top right corner, and then select Connect Locally. Get into the driver seat, and then close the

     Seals Body Closures

     Closeout Panel - Door - Front - LH (Remove and Install)

    SPECIAL TOOLS Rivnut Install Kit, for NA (Optional special tool if the thread for the closeout panel becomes stripped) (1054712-00-A ) Rivnut Install Kit, for EMEA (Optional special tool if the thr

    SEE MORE:

     Heater - PTC (Remove and Replace)

    Heater - PTC- Remove Remove Raise and support the vehicle on a 2 post lift. See Raise Vehicle - 2 Post Lift. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace). Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace). Rem

     Bracket - License Plate - Front (EMEA) (Retrofit using Template)

    Procedure Clean the front center surface of the front fascia. Align the template with the parking sensors, and then use masking tape to hold the template in place. LH side shown, RH side similar Align the front license plate bracket over the template, and then secure the bracket

    © 2019-2025 Copyright www.tmodel3.com