Tesla Model 3: ABS Traction and Stability Control
Tesla Model 3 2017-2025 Service Manual / Brakes / ABS Traction and Stability Control
- ABS Modulator (Remove and Replace)
- Sensor - Wheel Speed - ABS - Front - LH (Remove and Replace)
- Sensor - Wheel Speed - ABS - Rear - LH (Remove and Replace)
READ NEXT:
ABS Modulator - Remove
Remove
Raise and support the vehicle. See Raise Vehicle - 2
Post Lift.
Remove the 2nd row lower seat cushion. See Seat
ABS Modulator - Install
Install
Install the ABS modulator into the bracket.
Tighten the nuts (x2) that attach the ABS modulator
to the bracket.
Torque 8 Nm
SEE MORE:
Cover - Front - Seat Track - 1st Row Seat (Remove and Replace)
Remove
Move the seat fully rearward.
Release the clips at the rear of the seat track front cover that attach
the cover to the seat track, and then slide the cover forward off the track.
Install
Slide the seat track front cover rearward over the seat track, and then
fasten the clips
Automatic Emergency Braking
The forward looking camera(s) and the radar
sensor are designed to determine the distance
from a detected object traveling in front of
Model 3. When a frontal collision is considered
unavoidable, Automatic Emergency Braking is
designed to apply the brakes to reduce the
severity of the impact.
© 2019-2025 Copyright www.tmodel3.com
