Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Carpet - Front - LH (Remove and Replace)

Tesla Model 3 2017-2026 Service Manual / Interior Trim / Carpeting and Mats / Carpet - Front - LH (Remove and Replace)

DRAFT

Warning:

This procedure was derived from pre-production computer models, and might not reflect the real-world situation. Warnings and cautions might be missing. Follow safety requirements and use extreme caution when working on or near high voltage systems and components.

Do not redistribute this content.

Remove

  1. Remove the driver seat. See Seat - Driver (Remove and Replace).
  2. Remove the center console. See Center Console (Remove and Install).

Carpet - Front - LH (Remove and Replace)

  1. Release the clips that attach the LH front carpet to the vehicle.

Carpet - Front - LH (Remove and Replace)

  1. Release the clips that attach the driver footrest to the body, and then remove the LH front carpet from the vehicle.

Install

Installation procedure is the reverse of removal.

    READ NEXT:

     Carpet - Front - RH (Remove and Replace)

    Remove the front passenger seat. See Seat - Driver (Remove and Replace). Remove the center console. See Center Console (Remove and Install). Release the clips that attach the RH front carpe

     OBSOLETE - Carpet - Interior Complete (Remove and Replace)

    DRAFT Warning: This procedure was derived from pre-production computer models, and might not reflect the real-world situation. Warnings and cautions might be missing. Follow safety requirements

     Carpet - Rear (Remove and Replace)

    Remove Open all doors. Fully lower all windows. Move the driver and front passenger seats fully forward. Remove the 2nd row floor mat from the vehicle. Remove the 2nd row lower seat cushion.

    SEE MORE:

     Pressure Transducer - Low Pressure (Remove and Replace)

    Remove Recover the A/C refrigerant. See A/C Refrigerant (Recovery and Recharge). Note: Completely recover the refrigerant before continuing this procedure. Disconnect 12V power. See 12V Power (Disconnect and Connect). Disconnect the electrical connector to the low pressure transducer.

     Seal - Oil - Differential to Halfshaft - Front Drive Unit - LH (Remove and Replace)

    SPECIAL TOOLS Tool, Axle Extraction, Model 3 (1133386-00-A) Tool, Hub Puller, Hydraulic (1096075-00-A) Install Tool, Output Seal, Model 3 (1131206-00-A) Tool, Seal Puller, Adjustable (1052583-00-A) Remove Remove the LH front drive unit halfshaft. See Halfshaft - Front Drive Unit - LH (Remove an

    © 2019-2026 Copyright www.tmodel3.com