Tesla Model 3: Carpet - Front - RH (Remove and Replace)
- Remove the front passenger seat. See
Seat - Driver (Remove and Replace).
- Remove the center console. See
Center Console (Remove and Install).
- Release the clips that attach the RH front carpet to the vehicle, and
then remove the RH front carpet from the vehicle.
Install
Installation procedure is the reverse of removal.
READ NEXT:
DRAFT
Warning:
This procedure was derived from pre-production computer models, and
might not reflect the real-world situation. Warnings and cautions might be
missing. Follow safety requirements
Remove
Open all doors.
Fully lower all windows.
Move the driver and front passenger seats fully forward.
Remove the 2nd row floor mat from the vehicle.
Remove the 2nd row lower seat cushion.
DRAFT
Warning:
This procedure was derived from pre-production computer models, and
might not reflect the real-world situation. Warnings and cautions might be
missing. Follow safety requirements
SEE MORE:
Remove
Remove the underhood storage unit. See Underhood Storage Unit (Remove
and Replace).
Perform the A/C refrigerant recovery. See A/C Refrigerant (Recovery and
Recharge).
Remove the outer HVAC plenum duct. See Duct - HVAC Plenum - Outer
(Remove and Replace).
Disconnect the electrical
Remove
Open the rear trunk.
Lift up the trunk floor trim and remove it from the vehicle.
Tip:
Use the pull tab located at the rear edge of the trunk floor trim.
Install
Installation procedure is the reverse of removal.