DRAFT
Warning:
This procedure was derived from pre-production computer models, and
might not reflect the real-world situation. Warnings and cautions might be
missing. Follow safety requirements and
Remove the front passenger seat. See
Seat - Driver (Remove and Replace).
Remove the center console. See
Center Console (Remove and Install).
Release the clips that attach the RH front carpe
DRAFT
Warning:
This procedure was derived from pre-production computer models, and
might not reflect the real-world situation. Warnings and cautions might be
missing. Follow safety requirements
Remove
Open the rear trunk.
Lift up the trunk floor trim and remove it from the vehicle.
Tip:
Use the pull tab located at the rear edge of the trunk floor trim.
Install
Installation procedure is the reverse of removal.
Remove
Disconnect 12V power.
Remove the LH front door trim panel.
Remove the LH front door inner belt seal.
Remove the LH front door outer belt seal.
Remove the LH front window motor/regulator assembly.
Remove the LH door exterior release handle.
Remove the LH front door latch.
Remove