Tesla Model 3: Gas Strut - Hood - LH (Remove and Replace)
Remove
- Open the hood.
- Use a prop to attach the hood assembly in the open position.
- Release the clip that attaches the hood gas strut to the hood mount.
- Release the clip that attaches the hood gas strut to the body mount, and
then remove the hood gas strut from the vehicle.
Install
Installation procedure is the reverse of removal, except for the following:
-
Lubricate the pivot points for the hood gas strut.
-
The rod end of the hood gas strut mounts to the body and the body side of
the hood gas strut mounts to the hood assembly.
READ NEXT:
Remove
Open the trunk, and support the trunk in the open position.
Release the clip that attaches the lower end of the LH trunk gas strut
to the hinge on the vehicle.
Release the cl
Remove
Remove the rear underhood apron. See Underhood Apron - Rear (Remove and
Replace).
Remove the cabin intake duct. See Duct - Cabin Intake (Remove and
Replace).
Remove the hood latch co
Remove
Remove the trunk assembly. See Trunk (Remove and Install).
Remove the LH side trunk trim. See Trim - Side - Trunk - LH (Remove and
Replace).
Use masking tape to mark the position of th
SEE MORE:
Active Grille Shutter (Remove and Replace)
Remove
Remove the cooling fan module. See Module - Cooling Fan (Remove and
Install).
Release the side clips that attach the active grille shutter to the
condenser fan module.
Release the lower clips that attach the active grille shutter to
Calibrate
Perform a 4-wheel alignment. See Four Wheel Alignment (Check and Adjust).
Connect a laptop with Toolbox to the vehicle.
With an assistant, use Toolbox to perform a radar drive cycle
calibration:
For new radar applications, proceed to step 4.
For existing radar applications,